AEG A51100TSW0 Посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера AEG A51100TSW0. AEG A51100TSW0 36 сторінок.

Location

The appliance should be installed well away from

sources of heat such as radiators, boilers, direct

sunlight etc. Ensure that air can circulate freely

around the back of the cabinet.To ensure best

performance, if the appliance is positioned below

an overhanging wall unit, the minimum distance

between the top of the cabinet and the wall unit

must be at least 100 mm . Ideally, however, the

appliance should not be positioned below over-

hanging wall units. Accurate levelling is ensured

by one or more adjustable feet at the base of the

cabinet. If the cabinet is placed in a corner and

the side with the hinges facing the wall, the dis-

tance between the wall and the cabinet must be at least 10 mm to allow the door to open

enough so that the shelves can be removed.

WARNING!

It must be possible to disconnect the appliance from the mains power supply; the plug

must therefore be easily accessible after installation.

Door reversibility

To carry out the following operations, we suggest that this be made with another person

that will keep a firm hold on the doors of the appliance during the operations.

To change the opening direction of the door, do these steps:

Remove the plug from the power socket.

Tilt back the appliance carefully so that the compressor cannot touch the floor.

Unscrew the adjustable feet, situated on

both sides at the front .

Remove the lower door hinge by un-

screwing the 2 retaining screws.

Remove the hinge pin from the bottom

of the door.

Slot the hinge pin into the hole in the

hinge plate.

Take the door off.

Refit the upper hinge pin into the oppo-

site location.

Fit the door in place on the hinge pin.

10. Slot the hinge pin into the hole in the

hinge plate and relocate the hinge as-

sembly to the opposite location and refit using the retaining screws.

Installation