AEG ABE812E6NC Посібник користувача - Сторінка 15
Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера AEG ABE812E6NC. AEG ABE812E6NC 40 сторінок.
Також для AEG ABE812E6NC: Інструкція з монтажу (12 сторінок)
Друкувати сторінку
Problem
The compressor does not
start immediately after
pressing the "Frostmatic", or
after changing the tempera-
ture.
Door is misaligned or inter-
feres with ventilation grill.
Door does not open easily.
There is too much frost and
ice.
Water flows on the floor.
Possible cause
Food products placed in the
appliance were too warm.
The door is not closed cor-
rectly.
The Frostmatic function is
switched on.
The compressor starts after a
period of time.
The appliance is not level-
led.
You attempted to re-open
the door immediately after
closing.
The door is not closed cor-
rectly.
The gasket is deformed or
dirty.
Food products are not wrap-
ped properly.
Temperature is set incorrect-
ly.
Appliance is fully loaded and
is set to the lowest tempera-
ture.
Temperature set in the appli-
ance is too low and the am-
bient temperature is too
high.
The melting water outlet is
not connected to the evapo-
rative tray above the com-
pressor.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "Closing the door"
section.
Refer to "Frostmatic func-
tion" section.
This is normal, no error has
occurred.
Refer to installation instruc-
tions.
Wait a few seconds between
closing and re-opening of
the door.
Refer to "Closing the door"
section.
Refer to "Closing the door"
section.
Wrap the food products bet-
ter.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Set a higher temperature.
Refer to "Control Panel"
chapter.
Attach the melting water
outlet to the evaporative
tray.
15