AEG SCT71906S0 Посібник користувача - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера AEG SCT71906S0. AEG SCT71906S0 24 сторінки.

Друкувати сторінку

www.aeg.com

Problem

Water flows on the floor.

The temperature in the ap-

pliance is too low/too high.

If the advice does not lead

to the desired result, contact

the nearest Authorised

Service Centre.

8.2 Replacing the lamp

The appliance is equipped with a longlife

LED interior light.

Only service is allowed to replace the

lighting device. Contact your Authorised

Service Centre.

9. INSTALLATION

9.1 Positioning

Install the appliance in a dry, well

ventilated indoors where the ambient

temperature corresponds to the climate

class indicated on the rating plate of the

appliance.

Possible cause

Food products prevent

that water flows into the

water collector.

The melting water outlet is

not connected to the

evaporative tray above the

compressor.

The temperature regulator

is not set correctly.

The door is not closed cor-

rectly.

The food products' tem-

perature is too high.

Many food products are

stored at the same time.

The door has been

opened often.

There is no cold air circula-

tion in the appliance.

8.3 Closing the door

1. Clean the door gaskets.

2. If necessary, adjust the door. Refer to

assembly instructions.

3. If necessary, replace the defective

door gaskets. Contact the Authorised

Service Centre.

Climate

class

Solution

Make sure that food products

do not touch the rear plate.

Attach the melting water out-

let to the evaporative tray.

Set a higher/lower tempera-

ture.

Refer to "Closing the door".

Let the food products temper-

ature decrease to room tem-

perature before storage.

Store less food products at the

same time.

Open the door only if necessa-

ry.

Make sure that there is cold air

circulation in the appliance.

Ambient temperature

+10°C to + 32°C

+16°C to + 32°C

+16°C to + 38°C