AEG SKE81811DC Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Морозильна камера AEG SKE81811DC. AEG SKE81811DC 20 сторінок.
Друкувати сторінку
Problem
The compressor operates
continually.
The compressor does not
start immediately after
pressing the "COOLMAT-
IC", or after changing the
temperature.
Water flows inside the refrig-
erator.
Water flows on the floor.
Temperature cannot be set.
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The "COOLMATIC" is
switched on.
This is normal, no error has
occurred.
Food products prevent the
water to flow into the wa-
ter collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
The "COOLMATIC func-
tion" is switched on.
The appliance is in demon-
stration mode.
The temperature regulator
is not set correctly.
ENGLISH
Solution
Contact the nearest Author-
ised Service Centre.
Refer to "Operation".
Wait few hours and then check
the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Refer to "COOLMATIC func-
tion".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "COOLMATIC func-
tion" manually, or wait until
the function resets automati-
cally to set the temperature.
Refer to "COOLMATIC func-
tion".
Keep the OK pressed for ap-
proximately 10 seconds until a
long sound is heard and dis-
play shuts off for a short time.
Set a higher/lower tempera-
ture.
13