AEG 2060 D Посібник з експлуатації та встановлення - Сторінка 16

Переглянути онлайн або завантажити pdf Посібник з експлуатації та встановлення для Вентиляційна витяжка AEG 2060 D. AEG 2060 D 19 сторінок. Electrolux cooker hood operating and installation instructions 2060 d
Також для AEG 2060 D: Інструкція з експлуатації та монтажу (20 сторінок), Посібник з експлуатації та встановлення (19 сторінок)

Wall unit mounting - Fig. 6

• Position the template (1) on the wall and mark the position, and drill

(2) the holes (2 x Ø 8 mm).

• Mount the two rawl plugs with the hooks (3).

• Hang the hood on the hooks and level it with the adjustment screws

(4).

• Remove the grease filters (5) and mark for the two screws (6).

Remove the hood and drill the holes (2 x Ø 8 mm).

• Insert the rawl plugs (7) and hang the hood on the wall again. Adjust

it horizontally with the screws (8) and secure it with the screws (9).

• Mount the chimney holder (10) with the rawl plugs (9) and the

screws (11).

Be careful that it is centered over the hood and horizontally aligned.

• Fitting for extractor version (S): Connect a tube between the

hood air outlet and the wall or roof exhaust channel. Note that the

top part of the chimney can be mounted with the side grids up or

down. For use as an extractor version hood it must be mounted with

the grids downwards.

Fitting for filter version (K): Mount the deflector (12) with the two

screws (13 - 2,9 x 13) supplied.

• Make electrical connection (14) (see paragraph "Electrical

connection")

• Place the chimney (15) and fix it to the top chimney holder with the

two screws (16 - 3 x 9) supplied.

Lower the bottom part of the chimney and fasten it to the top of the

hood with two screws (17 - 3 x 9), supplied.