AEG 740 D Інструкція з експлуатації та монтажу - Сторінка 15

Переглянути онлайн або завантажити pdf Інструкція з експлуатації та монтажу для Вентиляційна витяжка AEG 740 D. AEG 740 D 16 сторінок.

Wall unit mounting - Fig. 7

• Rest the boring template (1) supplied with the hood against the

bottom of the overhead unit (the printed arrow indicates the side of

the template that has to coincide with the rear edge of the overhead

unit).

• Drill the holes required to fix the hood (2) and an additional hole in

the top and bottom of the unit (3) through which to pass the outlet

pipe and the electrical cable.

• The exhaust pipe (4) must be connected to the outside if the hood is

to be used in extractor mode, whereas it must be cut in

correspondence with the top of the overhead unit if the hood is to be

used in filtering mode.

• Connect the exhaust pipe to the hood connector ring (5) (The

connector ring must be mouted on the hood outlet hole – snap-on

connection fastened (6) with a screw).

Provide for electrical connection (7).

• From the inside of the unit, insert the 4 screws required to fix the

hood, and lock them firmly (8).

• Adjust opening of the drawer:

Remove the grease filters (9).

Loosen the screws and move the brackets regulating the drawer stop

forwards or backwards (10), so that when the drawer is closed it is

level with the outside edge of the adjacent overhead units.

Lock the bracket screws and replace the grease filters.