AEG CHDD 8694 Інструкція з експлуатації та монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з експлуатації та монтажу для Вентиляційна витяжка AEG CHDD 8694. AEG CHDD 8694 20 сторінок. Cooker hood
Також для AEG CHDD 8694: Інструкція з експлуатації та монтажу (20 сторінок), Інструкція з експлуатації та монтажу (20 сторінок)
Друкувати сторінку
Using the Remote Control
Button 1 = ON / 1
Button 2 = Timer ON/OFF
Button 3 = Light ON/OFF
Setting the Remote Control
Before using the remote control, first
programme it with the hood:
Push Button 4+5, keep both buttons
pressed for at least 3 seconds.
A beep will sound to indicate that the
programming mode has been
accepted.
Without releasing the buttons, press
any one of the remote control buttons.
A beep will sound to indicate that the
code has been accepted and stored.
Remote Control
Maintenance
Clean the remote control using non
abrasive detergents.
Follow the instructions below in order
to replace the battery for the remote
control :
• Raise the cover on the base of the
remote control, in order to access
the battery compartment.
• Remove the old battery and replace it with a new battery type 23A
12V
• Fit the new battery taking care to check the polarity as indicated on
the base of the battery compartment.
Warning!
If the remote control doesn't work , do the following before
calling your local AEG Service Force Centre:
• Disconnect the hood from the mains.
• Reconnect the hood to the mains.
• Repeat the procedure described on paragraph "Setting the remote
control"
Follow this procedure whenever the remote control doesn't work for
any apparent reason (e.g.: dead battery).
st
nd
Speed / 2
Speed / 3
rd
th
Speed/4
Speed/OFF
Button 2
Button 1
Button 3
Battery
compartment
cover
Control
Lamp
9