A-Neuvideo HD-88 Інструкція з експлуатації - Сторінка 13
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Матричний комутатор A-Neuvideo HD-88. A-Neuvideo HD-88 14 сторінок. 8x8 hdmi matrix switcher
Друкувати сторінкуMORE STUFF
Note: Turning the unit System Power 011 via RS-232 will extinguish the LED channel display leaving only the Power SW~ LED
on. The Video and Audio outputs will also mute. While the unit is turned 011 by RS-232 it will continue to accept and act
upon switching commands. For example, if the unit is in the off mode (via RS-232) and you send a command to switch
an input to an output that route will complete and the video and audio will now appear on that channel only. The front
panel LED channel display for that particular output will also show the input selected (for that single output channel
only). The remaining LED's will remain off and video and audio outputs muted. The unit will still return status and
change messages in response to commands sent while in Power Off state. A hard reset command (SBALLRST) will
return the unit to normal operation and also unlock the front panel.
Power Off mode.
- Put system into Standby (Soft Power Off)
SBSYSMOF
- Bring unit out of Standby (Soft Power On)
SBSYSMON
Unit will respond with
- Unit is in Standby
SBALOFAK
- Unit is no longer in Standby
SBALONAK
Example: Put Unit in Standby (Soft Power)
-Send
SBSYSMOF
-Rcvd
SBALOFAK
FRONT PANEL LOCK
Note: Hard resetting the unit will unlock the Front Panel controls.
- When front panel is locked, changes can only be made by RS-232
SBSYSMLK
- Front Panel Unlock
SBSYSMUK
Unit will respond with
- Front Panel has been Locked
SBSYSLOK
- Front Panel has been Unlocked
SBSYSULK
Example: Lock Front Panel Buttons
-Send
SBSYSMLK
-Rcvd
SBSYSLOK
UNIT RESET
- Reset every output to Input 1
SBALLRST
Unit will respond with
- Unit has reset each Output to Input 1
SBRSTACK
Example: Reset all outputs to Input 1
-Send
SBALLRST
-Rcvd
SBRSTACK
RS-232 SERIAL COMMANDS
12