A-Neuvideo EP-132 Інструкція з експлуатації - Сторінка 5
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Конвертер мультимедіа A-Neuvideo EP-132. A-Neuvideo EP-132 20 сторінок. Serial to ethernet converter
Друкувати сторінкуA
NEUVIDEO
FEATURES
• Data Conversion between RS-232/422/485 and Ethernet: Convert serial device (RS-232, RS-422, RS-485) data/signal into TCP/
IP packet data/signal and send them out with Ethernet data stream or convert the TCP/IP packet data/signal into serial device
data/signal.
• Dynamic IP Configuration: Support DHCP client mode, simplifying network address configuration and management.
• Dual LAN Speed: Support 10/100 Mbps Ethernet, auto-detected.
• Server/Client Dual Modes: EP-132 Series can be configured as network server or network client. In client mode, it can be installed
in network which protected by NAT router or firewall, without the need of a real IP address.
• Web-based Setup: Parameters setup based on HTTP protocol by using standard browsers (IE and Netscape). No special software
would be required.
• Built-in Security Control: Protected setup the password to prevent intruders.
• Firmware Remote Update: Firmware can be updated directly via Ethernet network to keep up with latest network standards.
SPECIFICATIONS
• CPU: 32-bits EP-132 CPU, 25 MHz
• RAM: 2MB SDRAM (1M x16Bits)
• ROM: 128KB Flash ROM
• Ethernet:
• Port Type: RJ-45 Connector
• Speed: 10/100Mbps (Auto Detecting)
• Protocol: ARP, IP, ICMP, UDP, TCP, HTTP, DHCP
• Mode: TCP Server ,TCP Client , UDP
• Setup: HTTP Browser Setup (IE & Netscape), RS-232 Console
• Security: Setup Password
• Protection: Built-in 1.5KV Magnetic Isolation
• Serial Port
• No. of Ports: 1x RS-232 / 1x RS-422/RS-485
• Speed: 300 bps~230.4 Kbps
• Parity: None, Odd, Even, Mark, Space
• Data Bit: 5, 6, 7, 8
• Stop Bit: 1, 2
• RS-232 Signals: Rx, Tx, GND, RTS, CTS, DTR, DSR, DCD
• RS-422 Signals: Rx+, Rx-, Tx+, Tx- (Surge Protection)
• RS-485 Signals: Data+, Data- (Surge Protection)
• Built-in RS-422/RS-485 Terminal Resistor
• 15KV ESD for all signal
• Watch Dog Function
• Power: DC9–12V, 500mA
• lED lamp: SYS (PWR), LAN, Rx, Tx
• Environment: Operating Temperature: 32°F~122°F (0°C~50°C) / Storage Temperature: 14°F~158°F (-10°C~70°C)
• Dimensions (WxDxh): 4.3 x 3.5 x 1.2 in (110x90x30mm)
• Weight: 5 oz (146 grams)
As product improvements are continuous, specifications are subject to change without notice.
FEATURES & SPECIFICATIONS
3