A-Neuvideo ANI-705XBDT Інструкція з експлуатації - Сторінка 5

Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Передавач A-Neuvideo ANI-705XBDT. A-Neuvideo ANI-705XBDT 8 сторінок. Hdmi over cat5e/6/7 transmitter and receiver with bi-directional poc

Друкувати сторінку
A
NEUVIDEO
Transmitter Front & Rear Panels
q
w
HDMI IN:
Connect to HDMI source equipment such as a DVD or Blu- ray player.
q
lAN:
Connect to an internet or network connection.
w
RS-232 IN:
Connect to a PC or laptop with D-sub 9-pin male cable for the transmission of RS-232 commands.
e
POWER
lED: This blue LED will illuminate when the transmitter is connected to a power supply.
r
DC 24V:
Plug the 24 V DC power supply into the unit and connect the adaptor to an AC outlet.
t
Note: Only a single unit needs to be powered and can power the other unit via PoC.
IR1 BlASTER:
Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR blaster in direct line-of-sight of the
y
equipment to be controlled.
IR2 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception. Ensure that remote being used is within the direct
u
line-of-sight of the IR extender.
lINK lED:
The yellow LED will illuminate when both the input and output signals are connected.
i
CAT5E/6 OuT:
Connect to the receiver unit with an single CAT5e/6 cable for transmission of all data signals.
o
Receiver Front & Rear Panels
q
w
HDMI OuT:
Connect to a HDMI equipped TV/monitor for display of the HDMI input source signal.
q
lAN:
Connect to a PC or Laptop to the Internet or network connection.
w
RS-232 OuT:
Connect to the device that is to be controlled (via D-sub 9-pin female cable) by RS-232 commands.
e
POWER lED:
This blue LED will illuminate when the receiver is receiving a power supply via PoC from a compatible transmitter unit.
r
DC 24V:
Plug the 24 V DC power supply into the unit and connect the adaptor to an AC outlet.
t
Note: Only a single unit needs to be powered and can power the other unit via PoC.
IR2 BlASTER:
Connect to the supplied IR Blaster cable for IR signal transmission. Place the IR blaster in direct line-of-sight of the
y
equipment to be controlled.
IR1 EXTENDER:
Connect to the supplied IR Extender cable for IR signal reception. Ensure that remote being used is within the direct
u
line-of-sight of the IR extender.
lINK lED:
The yellow LED will illuminate when both the input and output signals are connected.
i
CAT5E/6 IN:
Connect to the transmitter unit with an single CAT5e/6 cable for transmission of all data signals.
o
OPERATION CONTROLS & FUNCTIONS
e
r t y u
e
r t y u
3
i o
i o