AEG X66453MVO Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Вентиляційна витяжка AEG X66453MVO. AEG X66453MVO 20 сторінок. Cooker hood
Також для AEG X66453MVO: Посібник користувача (36 сторінок), Посібник з монтажу (12 сторінок)

Друкувати сторінку

Alarm signal reset

• Turn the Lights and the Suction motor off.

• Press button H and hold for at least 2 seconds, con-firmation

is provided by the fact that the Led goes out.

Before carrying out any maintenance or cleaning isolate

the cooker hood from the mains supply.

Charcoal Filters

In the recirculation mode the charcoal filters absorb smells and

unwanted odours.

This filter cannot be washed or regenerated, and must be repla-

ced when the Led on Button H starts to flash, or at least every

4 months. The alarm can only be seen when the Suction motor

is turned on.

Enabling/Disabling the alarm signal

• For Recirculation Version Hoods, the Filter saturation alarm

must be enabled on installation or at a later date.

• Turn the Lights and the Suction motor off.

• Press button H and hold for at least 5 seconds until the Led

gives confirmation as follows:

• Led flashes twice - Activated Charcoal Filter Alarm ENA-

BLED.

• Led flashes once - Activated Charcoal Filter Alarm DISA-

BLED..

To Remove the Charcoal Filters

• Open the panel by pulling from the center.

• Remove the metal grease filters

• Remove the saturated activated charcoal filter as shown

(A).

• Fit the new filters (B).

• Replace the metal grease filters.

This appliance can be a possible fire hazard if the grease

and charcoal filters are not cleaned and replaced as

recommended.

MAINTENANCE AND CLEANING