Kohler 10-Jet K-1000-H2 Посібник для власників житла - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для власників житла для Сантехніка для ванної кімнати Kohler 10-Jet K-1000-H2. Kohler 10-Jet K-1000-H2 48 сторінок. Tower custom hydro-massage system
Також для Kohler 10-Jet K-1000-H2: Посібник для власників житла (45 сторінок)
Друкувати сторінку
Using the Remote
The remote control places the user keypad functions at your fingertips to further enhance your
hydro-massage experience. The functions of the remote are identical to the user keypad. You may
turn the system on and off, turn the heater on and off, and access/modify all hydro-massage
functions.
The mode selector button functions in the same way as the outer ring. When "M" is pressed, one of
the modes will flash on the user keypad. If "M" is pressed again, the next mode in clockwise order
will flash. When the desired mode is flashing, press "OK" to activate it.
When the bodyjets or waterfall mode is active, the arrows will increase or decrease the water flow
volume for the selected mode.
The waterproof remote control is designed to be used in the bath and will float in the water.
Two AAA batteries are used in the remote control. To replace, simply unscrew the end cap and
insert the batteries, as shown above. Tighten the end cap securely, making sure the end cap makes
contact with the seal.
Programming the Remote
NOTE: Programming of the remote control is normally not required. If more than one device in your
home or in the near vicinity of your home uses a remote control, it may be necessary to program this
remote control to the user keypad. If you replace your remote control, or replace the pump control, it may
be necessary to program the remote control.
Turn the hydro-massage system power on.
Turn off all modes of operation. Wait approximately one minute until the keypad darkens
completely (sleep mode).
On the user keypad, press the up arrow, down arrow and the "OK" button simultaneously. The
bottom LED, on the keypad's indicator bar, will begin flashing.
While the LED is flashing, press the "OK" button on the keypad. A light sequence will illuminate
up and down the indicator bar.
While the indicator bar light sequence is active, press any button on the remote control. The
program will download and the user keypad will darken. The user keypad will now respond only
to this remote control.
FCC Compliance
FCC ID : N82-KOHLER001
Canada ID : 4554A-KOHLER001
Compliance Statement (Part 15.19)
Kohler Co.
Activates
Mode Selected
Mode
Selector
Power
Increases
Flow
Decreases
Flow
7
1030200-5-A