Kohler K-1257 Посібник з монтажу - Сторінка 2

Important Information

DANGER: Risk of electric shock. Connect only to a circuit protected by a Ground-Fault

Circuit-Interrupter (GFCI).

WARNING: When using electrical products, basic precautions should always be followed, including

the following:

WARNING: Risk of electric shock. A licensed electrician should make all electrical connections.

WARNING: Risk of electric shock. Disconnect power before servicing.

WARNING: Risk of injury or property damage. Please read all instructions thoroughly before

beginning installation, including the following requirements.

NOTICE: Follow all local plumbing and electrical codes.

Grounding is required. The unit should be installed by a qualiﬁed service representative, and grounded.

Building materials and wiring should be routed away from the blower motor body and other heat-producing

components of the unit.

Install to permit access for servicing.

The installation must have a Class A Ground-Fault Circuit-Interrupter (GFCI). The GFCI protects against

line-to-ground shock hazard. Use a 120 V, 15 A, 60 Hz dedicated service for the bath with airjets.

NOTE: If the pump supply cord is damaged, it must be replaced by the manufacturer, its service agent or

similarly qualiﬁed persons in order to avoid a hazard.

WARNING: Unauthorized modiﬁcation may cause unsafe operation or affect performance of the

bath with airjets. Do not relocate the blower motor, or make other modiﬁcations to the system in the

absence of kit instructions, as this could adversely affect the performance and safe operation of the

bath with airjets. Kohler Co. shall not be liable under its warranty or otherwise for personal injury or

damage caused by any such unauthorized modiﬁcation.

WARNING: Keep the area around the blower motor clean and free of debris. Ensure that the area

around the blower motor is free of sawdust, insulation, dirt, or other small loose debris. Such material

could clog the blower motor air ducts and reduce the air ﬂow through the blower.

Factory installed components include blower motor with power supply cord, check valve, air piping, user

keypad, and keypad cable. Other than power wiring and plumbing, no assembly is needed.

NOTICE: Provide unrestricted service access to the blower motor. You must provide access for servicing

the blower motor and check valve. The access must be located immediately next to the blower motor.

Study the roughing-in information packed with the bath.

Before installation, ensure that there is proper access to the blower motor and ﬁnal connections. If the blower

motor is installed in an enclosed area, an access panel is required at the blower motor. This panel should be

1040292-2-C

Kohler Co.