AEG LAVATHERM 97689IH3 Посібник користувача - Сторінка 19

Переглянути онлайн або завантажити pdf Посібник користувача для Сушарка AEG LAVATHERM 97689IH3. AEG LAVATHERM 97689IH3 28 сторінок.

Друкувати сторінку

AEG LAVATHERM 97689IH3 Посібник користувача

3. Set a new programme.

9.10 Programme end

Clean the filter and drain the

water container after each

drying cycle. (See chapter

CARE AND CLEANING.)

If the drying cycle has finished, the

symbol

flashes on the display. If the

Buzzer option is activated, the acoustic

signal sounds intermittently for 1 minute.

10. HINTS AND TIPS

10.1 Ecological hints

• Spin the laundry well before drying.

• Do not exceed the load sizes which

are specified in the programme chart.

• Clean the filter after each drying

cycle.

• Do not use fabric softener to wash

and then dry. In the tumble dryer

laundry becomes soft automatically.

• Use distilled water like that used for

steam ironing. If it is necessary, clean

the distilled water before (e.g. with a

coffee filter) to remove any particles.

• Always keep the airflow slots at the

bottom of the appliance clear.

• Make sure there is good airflow where

the appliance is to be installed.

10.2 Adjustment of dryness

levels

To change the default dryness level:

1. Turn the appliance on.

2. Wait approximately 8 seconds.

3. Select 1 of the available

programmes.

4. Touch and hold down the Dry Plus

and Spun at RPM option fields at the

same time.

If you do not turn off the

appliance, the anti-crease

phase starts. Laundry can be

removed during this phase.

To remove the laundry:

1. Push the On/Off button for 2

seconds to turn the appliance off.

2. Open the appliance door.

3. Remove the laundry.

4. Close the appliance door.

One of the symbols appears on the

display:

- Maximum dryness

- Extra dryness

- Standard dryness

5. Touch the Start/Pause field

repeatedly until you reach the

desired dryness level.

6. To set the new dryness level as the

default, touch the Dry Plus and Spun

at RPM option fields for

approximately 2 seconds at the same

time.

10.3 Deactivating the tank

indicator

The water container indicator is activated

by default. It illuminates at the end of the

drying cycle or during the cycle if the

water reservoir is full. If the draining kit is

installed the water container is drained

automatically and the indicator can be

deactivated.

To deactivate the indicator: