AEG LAVATHERM T35850 Посібник користувача - Сторінка 15

Переглянути онлайн або завантажити pdf Посібник користувача для Сушарка AEG LAVATHERM T35850. AEG LAVATHERM T35850 28 сторінок. Exhaust dryer

Changing the bulb for interior lighting

Only use a special bulb which is designed specially for dryers. The special bulb can be

obtained from your local service centre.

When the appliance is switched on, the interior lighting switches itself off after 4 minutes

when the door is open.

WARNING!

Do not use standard bulbs! These develop too much heat and may damage the machine!

Before replacing the bulb, disconnect the mains plug; with a permanent connection: fully

unscrew or deactivate the fuse.

1. Unscrew cover above the bulb (this can be found directly behind the loading aperture,

at the top; refer to "Description of machine" section.)

2. Replace defective bulb.

3. Screw cover back down.

Check the correct positioning of o-ring gasket before screwing back the door light cover.

Do not operate the dryer when missing o-ring gasket on door light cover.

WARNING!

For safety reasons, the cover must be screwed down tightly. If this is not done, the dryer

must not be operated.

Machine settings

1. Turn the programme selector to any programme. If the buzzer light is on, the buzzer

signal is active.

2. Press simultaneously the DELICATE and SENSITIVE buttons and hold down for approx.

5 seconds. The buzzer light is turn off. The buzzer signal is permanent off.

3. The buzzer is by default always off. You can use BUZZER button to activate or deactivate

sound but machine does not memorize your selection.

Water contains, a variable quantity of limestone and mineral salts of which quantities vary

according to geographical locations thus varying its conductivity values. Relevant varia-

tions of the conductivity of the water compared to those prefixed by the factory could

slightly influence the residual humidity of the laundry at the end of the cycle. Your dryer

allows you to regulate the sensitivity of the drying sensor based on conductivity values of

the water.

1. Turn the programme selector to any programme.

2. Press simultaneously the DELICATE and BUZZER buttons and hold down for approx. 5

seconds. The current setting is on the lights: light "EINDE (end) "– low conductivity

<300 micro S/cm, light "COOLING" – medium conductivity 300-600 micro S/cm,lightS

"COOLING "and "EINDE (end)"– high conductivity >600 micro S/cm

3. Press the START PAUSE button sequentially until you set desired level.

Machine settings