AEG LAVATHERM T76280IC Посібник користувача - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник користувача для Сушарка AEG LAVATHERM T76280IC. AEG LAVATHERM T76280IC 23 сторінки. Condensation dryer

Друкувати сторінку

• after you push the Start/Pause button

- all the push buttons and the pro-

gramme dial are deactivated

7.14 Starting a programme

To activate the programme push the

Start/Pause button. The LED above the

push button changes the colour to red.

7.15 Change a programme

To change a programme, push the On/

Off button to deactivate appliance. Push

the On/Off to activate the appliance and

then set the programme again.

8. HINTS AND TIPS

8.1 Ecological hints

• Do not use fabric softener to wash and

then dry. In the tumble dryer laundry

becomes soft automatically.

• Use the condensate as distilled water,

e.g. for steam ironing. If necessary

clean the condensate before (e.g. with

a coffee filter) to remove possible

small pieces of fluff.

• Always keep the airflow slots on the

bottom of the appliance clear.

• Use the load volumes specified in the

programmes chapter.

• Make sure that is good airflow in the

appliance installation position.

• Clean the filter after each drying cycle.

• Spin good the laundry before drying.

8.2 Water hardness and

conductivity

Water hardness can be different for dif-

ferent locations. Water hardness has an

effect on the water conductivity and the

operation of the conductivity sensor in

the appliance. If you know the value of

7.16 At the end of programme

When the drying cycle is completed, the

symbol flashes on the display. If the

Buzzer function is on, an acoustic signal

sounds intermittently for one minute.

To remove the laundry:

Push the On/Off button for 2 sec-

onds to deactivate the appliance.

Open the appliance door.

Remove the laundry.

Close the appliance door.

After each drying cycle:

• clean the filter

• drain the water container

(See chapter CARE AND CLEANING.)

the water conductivity you can adjust the

sensor to dry with the better results.

To change the sensor conductivity:

Turn the programme dial to availa-

ble programme.

Push at the same time the Dry Plus

and the Anticrease buttons. Hold

down until one of the symbols go in-

to view on the display:

–

low conductivity <300 μS/

–

moderate conductivity

300-600 μS/cm

–

high conductivity >600

μS/cm

Push the Start Pause button again

and again until you set necessary

level.

To memorise the setting push at the

same time the Dry Plus and the Anti-

crease buttons.

ENGLISH