Kohler 1198326-2-A Посібник з монтажу та догляду - Сторінка 5

Переглянути онлайн або завантажити pdf Посібник з монтажу та догляду для Ванни Kohler 1198326-2-A. Kohler 1198326-2-A 45 сторінок. 120 v bath with airjets

Друкувати сторінку

Option 1

Apply construction

adhesive.

Support Blocks

2. Install the Bath

NOTICE: Do not lift the bath by the piping or blower, or use the piping or blower for structural support

of the bath. To avoid damage to the bath, lift by the rim at the sides of the bath.

If the subﬂoor is not level, shim the bath support blocks or molded supports as necessary.

Option 1: Install Using Construction Adhesive

NOTE: Some models come with support blocks; some models have molded supports.

Apply a generous amount of high-quality construction adhesive to the bottom of the support blocks

or molded supports. With help, carefully lift the bath into position.

Option 2: Using a Cement or Mortar Bed

NOTE: Do not use gypsum cement or drywall compound for this application, as they will not provide an

acceptable, durable bond.

Set the basin area in 1" (25 mm) to 2" (51 mm) of mortar cement.

NOTE: The blower must rest directly on the subﬂoor. The blower should not be in contact with mortar.

Secure the Nailing-in Flanges (Alcove Units)

Drill a small pilot hole through the nailing-in ﬂange at each stud. Add shims as needed.

Use large-head galvanized nails to secure the nailing-in ﬂange to the studs.

Nail 1/4" (6 mm) thick furring strips to the studs.

Install the Plumbing

Kohler Co.

Option 2

Clear a space

for the blower.

Three Wall Alcove or Corner Installations

Stud

Furring

Strip

Nail

Cement or

Mortar Bed

Drill a small hole

through the nailing-in

flange at each stud.

1198326-2-A