Kohler K-1122P Посібник з монтажу - Сторінка 7

Переглянути онлайн або завантажити pdf Посібник з монтажу для Ванни Kohler K-1122P. Kohler K-1122P 48 сторінок. Drop-in bath with airjets canada

Bath

1/16"

(2 mm)

Tile

Brick

Approved Tile Backing

2. Prepare the Site - Concrete Construction

NOTICE: Do not support the bath by the rim.

NOTICE: Refer to the Roughing-in Guide packed with this product for proper minimum lbs/square foot

(kg/square meter) ﬂoor support loading.

NOTICE: Provide adequate ventilation and a minimum of 15 cubic feet (.4 cubic meters) in the installed

location for cooling the motor and to supply sufficient air for the blower. Do not install the blower motor

closer than 1" (2.5 cm) from the wall or other objects.

Make sure the ﬂooring offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

This bath may be installed in a drop-in or in an island installation. An island installation requires a

four side surround. In both instances, make sure the deck is supported by brick or concrete.

Install an access panel to allow the blower to be serviced.

Construct brick or concrete supports.

Provide a 1/16" (2 mm) gap between the bath rim and the concrete or brick framing. Frame the

ﬂoor, or construct a frame for a raised installation, in accordance with the roughing-in information

packed with the bath.

Position the plumbing according to the roughing-in information packed. Cap the supplies, and

check for leaks.

Install the drain to the bath according to the drain manufacturer's instructions. Do not connect the

trap at this time.

Position a clean drop cloth or similar material in the bottom of the bath to protect the ﬁnish. Be

careful not to scratch the surface of the bath.

Kohler Co.

Tile

Brick

Bath may be installed next

to the wall or as an island

installation.

Typical

access

panel

Install an access panel to allow

the pump to be serviced.

1034593-2-F