Kohler K-1127 Посібник з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник з монтажу для Ванни Kohler K-1127. Kohler K-1127 25 сторінок. Acrylic bath
Також для Kohler K-1127: Посібник з монтажу (25 сторінок), Посібник з монтажу та догляду (29 сторінок), Посібник з монтажу та догляду (25 сторінок), Посібник з чорнової обробки (4 сторінок)

Position

the rough

plumbing

Verify that the subfloor

offers adequate support,

and is flat and level

Alcove Installation

1. Prepare the Site

NOTICE: Adequate ﬂoor support must be provided. Consult the roughing-in sheet packed with your bath

for speciﬁc ﬂoor loading requirements.

WARNING: Risk of product damage. Do not support the bath by the rim.

Make sure the ﬂooring offers adequate support for your bath, and verify that the subﬂoor is ﬂat and

level.

This bath should be installed in an alcove or corner installation, depending on the model chosen.

When constructing the framing, allow for the thickness of the ﬁnished wall materials.

Construct 2x4 or 2x6 stud framing according to the roughing-in information packed with the bath.

Position the plumbing according to the roughing-in information. Cap the supplies and check for

leaks.

Unless the bath is elevated for an above-ﬂoor drain installation, a hole will need to be cut to

accommodate the drain connections. Refer to the roughing-in information.

NOTE: For corner installations, cut a hole large enough to allow for the diagonal positioning of the drain.

2. Prepare the Bath

Install the drain to the bath according to the drain manufacturer's instructions. Do not connect the

trap at this time.

Position a clean drop cloth or similar material in the bottom of the bath. Be careful not to scratch the

surface of the bath.

Kohler Co.

Construct 2x4 or

2x6 stud framing

according to the

roughing-in

information

1016757-2-C