Kohler ESCALE K-24913T-GS Інструкція з монтажу Посібник з монтажу - Сторінка 28
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Туалети Kohler ESCALE K-24913T-GS. Kohler ESCALE K-24913T-GS 45 сторінок.
Друкувати сторінку
4. Fitting the faceplate
4. 面板固定
Put the lock on the faceplate directly on the reversed lock
on the locking plate, then push the faceplate and lock it. The
installation shall begin from bottom to top.
将面板的扣位对准定位板的倒扣。然后用力向上推，再向前
扣紧。安装时要注意从下而上安装。
Two. Intelligent faceplate installation
Faceplate No.:
二 . 智能面板安装方式
面板编号：
K-23056T
K-24147T-7
1. Installing the cover
1. 遮板安装
As shown, first pass the full flush dark gray and half flush
blue air hoses, and the power output cable of the transformer
through the cover. Then push the cover forward until its lower
surface is attached to the hinge ear of the mask.
如图首先将大冲深灰色、小冲蓝色气管及变压器的电源输出线
穿过遮板后，向前推动遮板，直到遮板的表面下层贴在方外罩
的铰耳上。
Note: When installing the water tank faceplate by pressing
from front, with the difference between the ambient
temperature and the water temperature greater
than 10°C, it is recommended to add a cover to
the faceplate window. Purchase the suitable model
1414279-SP separately.
注： 水箱面板前按安装，环境温度与水温相差大于 10°C 时，
面板窗口建议增加遮板，请另购 1414279-SP。
2. Installing the locking plate
2. 定位板安装
A. When tightening the four fixation pipes on the locking
plate, adjust to the "OPEN" mark as shown.
A. 如图将定位板装上时，把四个固定管调整在标识 "OPEN"
字样装上。
B. Tighten the four fixation pipes to the "LOCK" mark after
installing locking plate as shown.
B. 如图将定位板装上后，把四个固定管旋到 "LOCK" 字样即
可。
1456149-K2-A
K-23056TW
K-78041-7
Faceplate
面板
Locking Plate
定位板
Lock
扣位
Locking Plate
定位板
-21-
Cover
遮板
Half Flush Blue Air Hose
小冲蓝色气管
Power Output Cable
变压器的电源输出线
Hinge Ear
Full Flush Dark Gray Air Hose
铰耳
大冲深灰色气管
Fixation Pipe
固定管
Fixing Lock
固定扣
Locking Plate
定位板
Fixation Pipe
固定管
Faceplate
面板