Kohler FAMILY CARE K-23188T-NS Інструкція з монтажу Посібник з монтажу - Сторінка 9
Переглянути онлайн або завантажити pdf Інструкція з монтажу Посібник з монтажу для Туалети Kohler FAMILY CARE K-23188T-NS. Kohler FAMILY CARE K-23188T-NS 10 сторінок. 3.0/4.8l vitreous china one piece toilet s-trap 305/400mm
Друкувати сторінку
QUICK REMOVAL AND INSTALLATION
(For K-23188T-ITNS/K-23189T-ITNS)
Quick Removal
Turn off water supply. Squeeze downward the blue part on
the fill valve base with one hand or non-sharp tools and
remove the fill valve by lifting it with the other hand. See
Fig.26.
Quick Installation
Squeeze downward the blue part on the fill valve base with
one hand or non-sharp tools to make sure it is ready for
assembly. See Fig.27. Confirm the direction of the float
canister and then insert the fill valve into the valve base until
it cannot be pushed any further with a 'clicking' sound. See
Fig.24. Turn on water supply and flush several times to check
for leakage.
SYMPTOMS
1. Poor Flush
2. No Flush
3. The fill valve turns on/off by itself
without the toilet being flushed, or it
runs allowing water to enter the tank.
4. Tank takes excessive time to fill.
5. There is excessive noise when the
tank is filling.
IMPORTANT: Use only genuine Kohler parts as shown to avoid property damage.
1392769-T01-C
Fig.#26
Not Ready
Ready For
For Assemble
Assemble
Fig.#27
27
CORRECTIVE ACTION
A. Adjust the tank water level to match the waterline.
B. Fully open the water supply shut-off valve.
C. Clear obstructions from the trapway, jet, or bowl rim holes.
D. Clear obstructions from the waste line.
A. Reconnect the chain to the trip lever or flush valve.
B. Adjust the chain assembly to remove excessive slack.
A. Adjust the chain for proper slack so the seal is not held off the flush valve seat.
B. Clean or replace the seal if it is worn, dirty, or misaligned with the flush valve seat, or
if the flush valve seat is damaged. Replace the flush valve seal or flush valve.
C. Clean the fill valve seat/seat washer of debris, or replace the piston/seat washer
assembly.
D. Remove the tank and tighten the flush valve nut if flush valve gasket is leaking. Do
not overtighten. If leakage continues, replace the gasket.
E. Adjust the tank water level if it is too high.
A. Fully open the water supply shut-off valve.
B. Clean the valve inlet, valve head, or supply line. Flush the lines.
A. Partially close the water supply shut-off valve if the water pressure to the toilet is too
high. Check the toilet performance following any such adjustment.
B. Remove dirt or obstructions from the valve head. Flush the lines.
-9-
(
K-23188T-ITNS/K-23189T-ITNS)
26
Fill Valve
Valve Base
26
27
24