Kohler 7000 Series Посібник користувача - Сторінка 6

Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler 7000 Series. Kohler 7000 Series 25 сторінок. 6000 series 7000 series
Також для Kohler 7000 Series: Посібник користувача (8 сторінок), Сервісний бюлетень (2 сторінок)

Друкувати сторінку

Oil Recommendations

We recommend use of Kohler oils for best

performance. Other high-quality detergent

oils (including synthetic) of API (American

Petroleum Institute) service class SJ or higher

are acceptable. Select viscosity based on air

temperature at time of operation as shown in

table below.

5W-30

°F -20

°C -30

-20

-10

Check Oil Level

NOTE: To prevent extensive engine wear or

damage, never run engine with oil level

below or above operating range

indicator on dipstick.

Ensure engine is cool. Clean oil ﬁ ll/dipstick

areas of any debris.

1. Remove dipstick; wipe oil off.

2. Reinsert dipstick into tube; press completely

down.

3. Remove dipstick; check oil level. Level

should be at top of indicator on dipstick.

4. If oil is low on indicator, add oil up to top of

indicator mark.

5. Reinstall and secure dipstick.

Change Oil and Filter

Change oil while engine is warm.

1. Clean area around oil ﬁ ll cap/dipstick.

Remove drain plug and oil ﬁ ll cap/dipstick.

Allow oil to drain completely.

2. Clean area around oil ﬁ lter. Place a container

under ﬁ lter to catch any oil and remove ﬁ lter.

Wipe off mounting surface. Reinstall drain

plug. Torque to 10 ft. lb. (13.6 N·m).

3. Place new ﬁ lter in shallow pan with open end

up. Fill with new oil until oil reaches bottom

of threads. Allow 2 minutes for oil to be

absorbed by ﬁ lter material.

4. Apply a thin ﬁ lm of clean oil to rubber gasket

on new ﬁ lter.

5. Refer to instructions on oil ﬁ lter for proper

installation.

6. Fill crankcase with new oil. Level should be

at top of indicator on dipstick.

10W-30

SAE 30

KohlerEngines.com

7. Reinstall oil ﬁ ll cap/dipstick and tighten

securely.

8. Start engine; check for oil leaks. Stop engine;

correct leaks. Recheck oil level.

9. Dispose of used oil and ﬁ lter in accordance

with local ordinances.

Oil Sentry

™

This switch is designed to prevent engine

from starting in a low oil or no oil condition. Oil

Sentry

may not shut down a running engine

™

before damage occurs. In some applications

this switch may activate a warning signal. Read

your equipment manuals for more information.

Fuel Recommendations

100

Gasoline is extremely ﬂ ammable and

its vapors can explode if ignited. Store

gasoline only in approved containers, in

well ventilated, unoccupied buildings, away

from sparks or ﬂ ames. Spilled fuel could

ignite if it comes in contact with hot parts or

sparks from ignition. Never use gasoline as a

cleaning agent.

NOTE: E15, E20 and E85 are NOT approved

and should NOT be used; effects of

old, stale or contaminated fuel are not

warrantable.

Fuel must meet these requirements:

● Clean, fresh, unleaded gasoline.

● Octane rating of 87 (R+M)/2 or higher.

● Research Octane Number (RON) 90 octane

minimum.

● Gasoline up to 10% ethyl alcohol, 90%

unleaded is acceptable.

● Methyl Tertiary Butyl Ether (MTBE) and

unleaded gasoline blend (max 15% MTBE by

volume) are approved.

● Do not add oil to gasoline.

● Do not overﬁ ll fuel tank.

● Do not use gasoline older than 30 days.

Fuel Line

Low permeation fuel line must be installed on

carbureted Kohler Co. engines to maintain EPA

and CARB regulatory compliance.

(if equipped)

WARNING

Explosive Fuel can cause ﬁ res

and severe burns.

Do not ﬁ ll fuel tank while engine is

hot or running.

32 590 16 Rev. A