Kohler 7500 Series Посібник користувача - Сторінка 5
Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler 7500 Series. Kohler 7500 Series 8 сторінок.
Maintenance Instructions
Accidental Starts can cause
severe injury or death.
Disconnect and ground spark
plug lead(s) before servicing.
Normal maintenance, replacement or repair of emission control devices and systems may be
performed by any repair establishment or individual; however, warranty repairs must be performed
by a Kohler authorized dealer found at KohlerEngines.com or 1-800-544-2444 (U.S. and Canada).
Maintenance Schedule
Every 25 Hours¹
● Service/replace precleaner.
● Replace LPAC element (if not equipped with precleaner).
Every 50 Hours¹
● Replace LPAC element (if equipped with precleaner).
● Replace high performance air cleaner element (if not equipped with precleaner).
Every 75 Hours¹
● Replace high performance air cleaner element (if equipped with precleaner).
● Replace PRO performance air cleaner element (if not equipped with precleaner).
Every 100 Hours¹
● Replace PRO performance air cleaner element (if equipped with precleaner).
● Change oil and fi lter.
● Remove cooling shrouds and clean cooling areas.
Every 100 Hours
● Check that all fasteners are in place and components are properly secured.
Every 200 Hours¹
● Replace unique EFI fuel fi lter.
Every 500 Hours²
● Have valve lash checked/adjusted.
Every 500 Hours
● Replace spark plugs and set gap.
¹ Perform these procedures more frequently under severe, dusty, dirty conditions.
² Have a Kohler authorized dealer perform this service.
Oil Recommendations
We recommend use of Kohler oils for best
performance. Other high-quality detergent
oils (including synthetic) of API (American
Petroleum Institute) service class SJ or higher
are acceptable. Select viscosity based on air
temperature at time of operation as shown in
table below.
5W-30
°F -20
0
20
°C -30
-20
-10
32 590 26 Rev. --
WARNING
10W-30
SAE 30
32
40
50
60
80
0
10
20
30
KohlerEngines.com
Before working on engine or equipment, disable
engine as follows: 1) Disconnect spark plug
lead(s). 2) Disconnect negative (–) battery cable
from battery.
Check Oil Level
NOTE: To prevent extensive engine wear or
damage, never run engine with oil level
below or above operating range
indicator on dipstick.
Ensure engine is cool and level. Clean oil fi ll/
dipstick areas of any debris.
1. Remove dipstick; wipe oil off .
2. Reinsert dipstick into tube; press completely
down.
3. Remove dipstick; check oil level. Level
should be at top of indicator on dipstick.
4. If oil is low on indicator, add oil up to top of
indicator mark.
100
40
5. Reinstall and secure dipstick.
EN
5