Kohler COMMAND CV-675-740 Посібник користувача - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler COMMAND CV-675-740. Kohler COMMAND CV-675-740 21 сторінка. Vertical crankshaft

Друкувати сторінку

Element Cover Nut

Element

zyxwvu

Air

Cleaner

Base

Rubber

I '

Seal

Stud

CV26 EFI Air

Cleaner Base

:igure 13. Air Cleaner System Components

Type B (Commercial Mower).

Service Precleaner

If so equipped, wash and reoil the precleaner every 25

hours of operation (more often under extremely dusty

or dirty conditions).

1. Loosen the cover retaining knob and remove the

cover.

2. Remove the precleaner from the paper element.

3. Wash the precleaner in warm water with

detergent. Rinse the precleaner thoroughly until all

traces of detergent are eliminated. Squeeze out

excess water (do not wring). Allow the precleaner

to air dry.

4. Saturate the precleaner with new engine oil.

Squeeze out all excess oil.

5. Reinstall the precleaner over the paper element.

6. Reinstall the air cleaner cover. Secure cover with

the cover retaining knob.

When precleaner replacement is necessary order

genuine Kohler Parts.

CV17-CV23

CV675, CV25, CV26

TYPeA

2 4 0 8 3 0 2 4

2 4 0 8 3 0 5 4

Type B

45 083 01-S

Service Paper Element

Every 100 hours of operation (more often under

extremely dusty or dirty conditions), replace the paper

element.

1. Loosen the cover retaining knob and remove the

cover.

2. Clean the area around the element to prevent

debris from getting in the engine when element is

removed.

3. Remove the element cover wing nut, element

cover, and paper element with precleaner.

Separate the precleaner from the element and

service as necessary.

4. Do not was the paper element or use

pressurized air, as this will damage the element.

Replace a dirty, bent, or damaged element with a

genuine Kohler element. Handle new element

carefully; do not use if the sealing surfaces are

bent or damaged.

5. When servicing the air cleaner, check the air

cleaner base. Make sure it is secured and not

bent or damaged. Also, check the element cover

for damage or improper fit. Replace all damaged

air cleaner components.

6. Check the condition of the rubber seal on the air

cleaner stud. If it is worn, damaged, or its

condition is questionable in any way, replace it.