Kohler COMMAND PRO CS Series Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler COMMAND PRO CS Series. Kohler COMMAND PRO CS Series 21 сторінка. Horizontal crankshaft
Також для Kohler COMMAND PRO CS Series: Посібник користувача (20 сторінок)
![Kohler COMMAND PRO CS Series Посібник користувача](/uploads/products/server2/2637888/2637888.png)
Muffler Screen and Spark Arrestor CS8.5,CS10,CS12
CAUTION!
The engine and muffler will be very hot after the engine
has been run. Avoid touching the engine and muffler
while they are still hot, with any part of your body or
clothing.
1. Remove the muffler screen.
2. Remove the spark arrestor using a flatblade
screwdriver.
3. Clean the carbon deposits out of the muffler
screen and spark arrestor using a wire brush.
CAUTION!
When cleaning, use the wire brush lightly to avoid
damaging or scratching of the muffler screen and
spark arrestor.
4. Check the muffler screen and spark arrestor,
replace if damaged.
5. Install the spark arrestor and muffler screen.
Figure 18. Muffler Screen and Spark Arrestor.
14
Carburetor Troubleshooting and
Adjustments
NOTE: Carburetor adjustments should be made only
after the engine has warmed up.
The carburetor is designed to deliver the correct
fuel-to-air mixture to the engine under all operating
conditions. The high idle mixture is set at the factory
and cannot be adjusted. The low idle fuel adjusting
needle is also set at the factory and has a limiting cap.
It normally does not need adjustment.
If the engine is hard to start, runs roughly, or stalls at
low idle speed, it may be necessary to adjust or
service the carburetor.
Idle Speed
Screw
Figure 19. Carburetor.
Troubleshooting
If engine troubles are experienced that appear to be
fuel system related, check the following areas before
adjusting the carburetor.
• Make sure the fuel tank is filled with clean, fresh
gasoline.
• Make sure the fuel tank cap vent is not blocked
and that it is operating properly.
• Make sure the fuel shut-off valve is fully open.
• Make sure fuel shut-off valve strainer, and in-line
fuel filter (if used) are clean and unobstructed.
Clean or replace as necessary.
Idle Fuel
Needle