Kohler Command PRO ECH749 Посібник користувача - Сторінка 13
Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler Command PRO ECH749. Kohler Command PRO ECH749 17 сторінок. Horizontal crankshaft
Також для Kohler Command PRO ECH749: Посібник користувача (8 сторінок)
Друкувати сторінку
Storage
1
See Figure
If the engine will be out of service for two months or
more, follow these storage procedures:
1.
Clean the exterior surfaces of the engine. Avoid
spraying water at the wiring harness or any of the
electrical components.
2.
Change the oil and filter while the engine is still
warm from operation. Refer to Change Oil and
Filter.
3.
The fuel system must be completely emptied,
or the gasoline must be treated with a fuel
stabilizer to prevent deterioration. If you choose
to use a fuel stabilizer, follow the manufacturers
recommendations, and add the correct amount
for the capacity of the fuel system.
4.
Fill the fuel tank with clean, fresh gasoline.
Run the engine for 2-3 minutes to get stabilized
fuel into the fuel system. Close fuel shut off
valve (if equipped) when unit is being stored or
transported. To empty the system, run the engine
until the tank and fuel system are empty.
5.
Remove the spark plugs. Add one tablespoon of
engine oil into each spark plug hole. Install plugs,
but do not connect the plug leads. Crank the
engine two or three revolutions.
6.
Disconnect the negative (-) battery cable or use a
Battery Minder trickle charger while the unit is in
storage.
7.
Store the engine in a clean, dry place.
Repairs
Repair information is available in Kohler Engine
service manuals which are available at
KohlerEngines.com, or at Kohler Service Centers.
Major repairs generally require the services of a
trained mechanic and the use of specialized tools and
equipment. Kohler Service Centers have the facilities,
training, and genuine Kohler replacement parts
necessary to perform these services.
For the nearest sales and service location, visit our
Web site at KohlerEngines.com, or in the U.S. and
Canada call 1-800-544-2444.
Parts Ordering
The engine model, specification, and serial numbers
are required when ordering replacement parts from
your Kohler Service Center. These numbers are found
on the identification plate which is affixed to the
engine shrouding. Include letter suffixes if there are
any. Refer to Engine Identification Numbers.
Always insist on genuine Kohler replacement parts, as
they adhere to strict standards for fit, reliability, and
performance. Visit KohlerEngines.com or your Kohler
Service Center.
Engine Identification
Engine Identification Numbers
1
See Figure
Engine identification numbers will appear on the
engine data tag (M). See Figure 1.
When ordering parts, or in any communication
concerning this engine, always give the model name,
specification number, and serial number — including
any letter suffixes.
Emission Compliance
The Emission Compliance Period referred to on the
Emission Control or Air Index label indicates the
number of operating hours for which the engine has
been shown to meet Federal and CARB emission
requirements. The following table provides the
Engine Compliance Period (in hours) associated with
the category descriptor which may be found on the
certification label.
Emission Compliance Period
EPA
Category A:1000 hours
CARB
Refer to certification label for engine displacement.
Exhaust Emission Control System for models ECH630,
ECH650, ECH680, ECH730, ECH740, ECH749 is EM,
O2S, ECM, MPI for U.S. EPA, California, and Europe.
Extended:500 hour
13