Kohler MAGNUM 18vhp Посібник користувача - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник користувача для Двигун Kohler MAGNUM 18vhp. Kohler MAGNUM 18vhp 17 сторінок. Vertical crankshaft
Друкувати сторінку
3. Gradually return the choke control to the "off"
position after the engine starts and warms up.
NOTE: After starting the engine, it may be
necessary to leave the choke partially
"on" for a few minutes before moving it
to the "off" position.
Stopping
1. Remove the load by disengaging all PTO
attachments.
2. Move the throttle control to the ''slow'' or ''low''
idle position. Allow the engine to run at idle for
30-60 seconds; then stop the engine. If the
carburetor on the engine is equipped with a fuel
solenoid, move the throttle control back up
between half and full throttle just before stopping
the engine.
Battery
A 12 volt battery with a rating of approximately 250 cold
cranking amps is normally used. Refer to the operating
instructions of the equipment this engine powers for
specific information.
If the battery charge is not sufficient to turn over the
engine, recharge the battery (see page 11).
Operating
Optional spark arrestor mufflers are available from your
Kohler Engine Service Dealer. Check your local laws
and statutes regarding engine spark arrestor muffler
requirements.
Angle of Operation
The maximum angles of operation are: 30° with
carburetor up or down; 25° with cylinders up or down.
(Intermittent operation with crankcase filled to "F" mark
on dipstick.)
NOTE: Do not exceed these angles of operation as
engine damage may result from lack of
lubrication.
Refer to the operating instructions of the equipment
this engine powers. It may have more stringent
guidelines as to angle of operation due to equipment
design.
Cooling
NOTE: If debris builds up on the grass screen or
other cooling air intake areas, stop the engine
immediately and clean. Operating the engine
with blocked or dirty air intake and cooling
areas can cause extensive damage due to
overheating.
WARNING: Hot Parts!
Engine components can get extremely hot from
operation. To prevent severe burns, do not touch these
areas while the engine is running–or immediately after
it is turned off. Never operate the engine with heat
shields or guards removed.
Engine Speed
NOTE: Do not tamper with the governor setting to
increase the maximum engine speed.
Overspeed is hazardous and will void the
engine warranty.
WARNING: Rope Starting Pulley Is Not a
Drive Pulley!
Do not use optional backup rope starting pulley as a
drive pulley. Using starting pulley as a drive could
loosen the flywheel fastener, resulting in bodily harm.
7