Kohler 10EORDB Операція - Сторінка 7

Переглянути онлайн або завантажити pdf Операція для Портативний генератор Kohler 10EORDB. Kohler 10EORDB 48 сторінок. Commercial/recreational mobile generator sets

Друкувати сторінку

CAUTION

Welding the generator set.

Can

cause

severe

equipment damage.

Never weld components of the

generator

set

without

disconnecting the battery, controller

wiring harness, and engine electronic

control module (ECM).

Servicing the generator set when it

is operating. Exposed moving parts

can cause severe injury or death.

Keep hands, feet, hair, clothing, and

test leads away from the belts and

pulleys when the generator set is

running. Replace guards, screens, and

covers before operating the generator

set.

Grounding

electrical equipment.

Hazardous

voltage

can

severe injury or death. Electrocution

is possible whenever electricity is

present. Ensure you comply with all

applicable

codes

and

Electrically ground the generator set,

transfer switch, and related equipment

and electrical circuits. Turn off the main

circuit breakers of all power sources

before servicing the equipment. Never

contact electrical leads or appliances

when standing in water or on wet

ground because these conditions

increase the risk of electrocution.

Welding on the generator set. Can

cause severe electrical equipment

damage.

Before welding on the

generator set perform the following

steps: (1) Remove the battery cables,

negative (--) lead first. (2) Disconnect

all engine electronic control module

(ECM) connectors. (3) Disconnect all

generator set controller and voltage

regulator circuit board connectors.

(4) Disconnect the engine battery-

charging

alternator

connections.

(5) Attach the weld ground connection

close to the weld location.

TP-6551 2/14

Short

voltage/current can cause severe

injury or death. Short circuits can

cause bodily injury and/or equipment

damage.

connections with tools or jewelry while

making

Remove all jewelry before servicing the

equipment.

electrical

Engine block heater.

voltage can cause severe injury or

death. The engine block heater can

first

cause electrical shock. Remove the

engine block heater plug from the

electrical outlet before working on the

block heater electrical connections.

Electrical backfeed to the utility.

Hazardous backfeed voltage can

cause

severe

Connect the generator set to the

building/campground electrical system

only through an approved device and

after the building/campground main

switch is turned off.

connections can cause severe injury or

death to utility personnel working on

power lines and/or personnel near the

cause

work area. Some states and localities

prohibit unauthorized connection to the

utility electrical system.

transfer

standards.

interconnection of the generator set

power and other sources of power.

Hot Parts

Hot coolant and steam.

Can cause severe injury or death.

Before removing the pressure cap,

stop the generator set and allow it to

cool. Then loosen the pressure cap

to relieve pressure.

Combustible materials.

cause severe injury or death. A hot

exhaust system can ignite adjacent

combustible materials. Do not locate

electrical

combustible

exhaust muffler.

when parking your vehicle to prevent

the exhaust system and hot exhaust

gases from starting grass fires.

circuits.

Hazardous

Do not contact electrical

adjustments

repairs.

Hazardous

injury

death.

Backfeed

Install a

switch

prevent

WARNING

Fire can

wiring,

fuel

lines,

materials

above

the

Exercise caution

Combustible materials.

cause severe injury or death. A hot

generator set can ignite debris in the

compartment. Keep the compartment

and generator set clean and free of

debris and combustible materials to

minimize the possibility of fire. Do not

block the fuel/oil drain opening in the

generator set mounting tray.

corresponding hole in the subfloor, if

used, for the drain opening.

Notice

NOTICE

Canadian installations only.

standby service connect the output of

the generator set to a suitably rated

transfer switch in accordance with

Canadian Electrical Code, Part 1.

NOTICE

This generator set does not comply

with United States Coast Guard

(USCG) requirements and must not

be used for marine applications. For

marine installations use only generator

sets specified for marine use. USCG

Regulation 33CFR183 requires that a

generator

set

must

protected

when

gasoline-fueled environment.

NOTICE

Saltwater damage. Saltwater quickly

deteriorates metals. Wipe up saltwater

on and around the generator set and

remove salt deposits from metal

surfaces.

Safety Precautions and Instructions

Fire can

Cut a

For

ignition

used