Kohler 14RESA Посібник з усунення несправностей - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник з усунення несправностей для Портативний генератор Kohler 14RESA. Kohler 14RESA 8 сторінок. Residential/commercial generator sets
Також для Kohler 14RESA: Інструкція з монтажу (4 сторінок), Інструкція з монтажу (2 сторінок), Операція (20 сторінок), Інструкція з монтажу та експлуатації (37 сторінок)

Software Updates

As each generation of Kohlerr Residential generator set

controls offers more features and options for the owner,

the troubleshooting of these controllers becomes more

difficult.

In addition, the software that controls the

operation of these controllers has increased in

complexity. Kohler Co. periodically releases updates to

the controller software when new models are released.

Software updates are also released to resolve issues on

older model products that have been found after the

product was manufactured.

Kohler Co. recommends updating the controller

software to the latest version whenever servicing

Kohlerr products or investigating a customer complaint.

This will ensure that the owner has the best software

available.

The current software versions for all Kohlerr Residential

products are located in TechTools on the Kohler Power

Resource Center and on the Dealer Portal. If you do not

have access to the Dealer Portal, please contact your

distributor. The Kohler Generator Service Department

will provide the most current version if it is not yet

available on TechTools or the Dealer Portal.

A laptop computer using Kohlerr SiteTecht software is

necessary for the update. SiteTech software is available

on TechTools and the Dealer Portal for Kohler

distributors and dealers only.

Connect the controller to the laptop computer using the

appropriate USB cable to update the firmware. Refer to

the

SiteTech

Software

instructions, if necessary.

complete, disconnect the USB cable and remove power

from the controller for one minute. This will allow the

large capacitor on the RDC2 logic board to discharge.

After one minute, reconnect power to the controller.

Operation

Manual

for

When the procedure is

SB-722

1/13