A. & H. Meyer NET+ Instagrid 230 V-PowerPack Короткий посібник - Сторінка 3

Переглянути онлайн або завантажити pdf Короткий посібник для Блок розподілу електроенергії A. & H. Meyer NET+ Instagrid 230 V-PowerPack. A. & H. Meyer NET+ Instagrid 230 V-PowerPack 3 сторінки.

Друкувати сторінку
NET+ Instagrid 230 V-PowerPack
QUICK GUIDE
After 10 seconds have elapsed, the LED indicator
and set the rotary switch
connected device).
Note: No charging below 0 °C.
4.2
TRANSPORT MODE
Set the rotary switch
[3]
The NET+ Instagrid 230 V-PowerPack can now be brought to the desired
location. Use the transport mode for any type of transport.
4.3
DISCHARGING
Deactivate the standby mode and activate the operating mode by turning the
rotary switch
[3]
from
start-up sequence, the device will
perform an initial self-test. If the
LEDs
[5]
go out after the start-up
sequence,
the
device
completely discharged and must
first be charged
(see section 4.1
CHARGING).
If one or more LEDs
green after the start-up sequence, the device is ready for operation via the outputs
Equipment can now be connected to either one of the two outputs
number of green LEDs
charge during operation. If the device is almost completely discharged, the LED on the far left will
flash green. The device should then be recharged as soon as possible
CHARGING). After operation, set the device to standby mode by turning the rotary switch
(see section 4.1
CHARGING), or activate the transport mode by turning the rotary switch
(see section 4.2 TRANSPORT
5.
STORAGE
Store the device in transport mode and without any connected cables or equipment.
Do not store the device in a discharged state for longer periods of time. This may cause deep
discharge of the device, requiring it to be recommissioned by the manufacturer.
Charge the device at least once every three months. For a long service life, store the device at
temperatures between 0 and 23 °C in a low-humidity environment.
[3]
either to
(to activate the transport mode) or to
to
(turn anticlockwise) to activate the transport mode.
to
(turn clockwise). While the LEDs
is
[5]
light up
[5]
indicates the current state of charge. Regularly check the state of
MODE).
[5]
will go out. Next, remove the charging cable
[5]
light up in the
[4 |
v.1.0
(to operate a
[4 |
9].
9]. During operation, the
(see section 4.1
[3]
[3]
to
to
3