Dexin MWP5016 Посібник користувача - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник користувача для Миша. Dexin MWP5016. Dexin MWP5016 8 сторінок. Standard rf optical mouse

Precaution

! For optimal performance, place the receiver at least 8 inches or 20 centimeters away

from other electrical devices, such as the computer, the computer monitor, speakers or

other external storage drives.

! For a better transmission distance, avoid using this device on a metal plate or

desktop because a large surface of iron, aluminum, copper and other metal will be a

shielding or ground to the RF antenna of the mouse and receiver. Operating on a metal

may cause the transmission distance shorter.

! For this RF optical mouse, it is not suggested operate the mouse on a dark surface

for the consideration of saving battery power, so the LED is not illuminated too bright.

Although the working surface is not strictly restricted, it is strongly recommended to operate

an optical mouse on a white paper to obtain the best performance.

! If your notebook computer or PC has a metal (contains Al or Mg) case, the metal

housing of the LCD panel will isolate partial radiation of the RF signal from the mouse. This

will possibly result in reducing the distance of transmission when you operate the mouse

right in front of the notebook or PC, and the receiver is connected on the back of the

notebook or PC.

the mouse just beside your notebook computer or PC

Installation Guide

Step 1. Connecting the Receiver

By using this MWP5016 mouse, you need to keep a free USB port for the included

receiver.

Please follow the steps below to finish the connecting:

1. Turn off your computer.

2. Plug the USB connector end of the receiver into the USB port. Of your notebook

( or PC) or your charge base if the charge base is already connected to your

notebook or PC through the USB cable.

3. Prepare your original Microsoft Windows CD.

4. Turn the notebook or PC power on, then follow the instructions of Windows to

complete the registration of a new USB device.

Step 2. Setting up the correct channel for both of receiver and mouse

This RF wireless mouse provides 2 different RF channels, and 256 identification codes to

avoid interference with other radio devices or other same model of RF wireless mouse.

Before you using the wireless mouse, please select the same RF channel (indicated by A

and B) by sliding the switch to A or B on both receiver and mouse. (See Fig. 3.1 and 3.2 for

the location of channel switch.)

However, the RF mouse should work properly while you are operating