AvLab AVLT-MT29-1 Посібник з монтажу - Сторінка 2
Переглянути онлайн або завантажити pdf Посібник з монтажу для Внутрішнє оздоблення приміщень AvLab AVLT-MT29-1. AvLab AVLT-MT29-1 2 сторінки. Electric dual motor sit-stand desk frame
Друкувати сторінку
INSTALLATION
2
Install the side plate (3) and use the wrench (E)
to lock the screw (C)
Insert the connecting rod (9) into the frame.
3
C
M6x16
3
Adjust the distance according to the size of the table,
and then tighten the screw (B) with the wrench (E).
B
M6x12
8PCS
E
4
Mount the desktop (1) with screws (A) on the two side plates
S=4mm
A
9
M5x16
8PCS
Mount the control box(8) under desktop(1) with screws (A).
5
Use the screws (A) to install the controller panel(2) under
the desktop (the left and right sides of the desktop can be
chosen)
6
1
A
M5x16 2PCS
Rip the protective film off before
the monitor is installed.
A M5x16 2PCS
OPERATION
Press
and display real height
Press
and display real height
Press
until 1 appears, release the button, it runs
to corresponding height and displays current position.
Press
until 2 appears, release the button, it runs
to corresponding height and displays current position.
Press
until 3 appears, release the button, it runs
to corresponding height and displays current position.
Press
until 4 appears, release the button, it runs
to corresponding height and displays current position.
Save button,used to enter the save height function
After
press , the interface flashes and set memory
M
Memory
position, press
until H1 appears, release button and
Position
it displays current height.
in condition of E2 or run to basic height position, long
press
for 5 seconds, display RES and press still, it
Reset
goes down to the lowest and rebound certain height,
reset finish and show basic height.
Protection mode (auto lock screen mode)
Over-heating
Hot: it alarms when continuous working 2 minutes;
protection
clear automatically after resting 18 minutes.
Sensorless
E1: It alarms when motor hall value cannot be inspected;
alarm
clear it after press reset or re-power on.
E2: overload alarm when running up, clear automatically
Overload
after 3 seconds; overload alarm when running down,
protection
clear it after press reset or re-power on.
E02: it alarms in reversed compression when running;
Rebound
clear automatically after rebound 4cm; or press any
protection
button to clear when rebounding.
Overvoltage
E03: it alarms when voltage is higher than limit value,
alarm
clear automatically after voltage reduced to set value.
Undervoltage
E05: it alarms when voltage is lower than limit value;
alarm
clear automatically after voltage is higher than set value.
E06: it alarms when height difference between left and
Step out alarm
right leg exceeds the set value; clear it after re-power on.
It stops and enters protection state when motor lines or
Breaking
manual control lines are removed or disconnected
protection
accidentally; back to normal after reconnected and alarm
cleared.
Press
M
for 3 seconds and it will display ---, release
press
until 0 appears, release the button and it
Metric and
displays current height. (metric unit)
English
Press
for 3 seconds and it will display ---, release
unit conversion
M
press
until 1 appears, release the button and it
displays current height. (English unit)
M
,
,
M