A.B.S. 23023 Посібник із швидкого старту - Сторінка 3

Переглянути онлайн або завантажити pdf Посібник із швидкого старту для Контролер A.B.S. 23023. A.B.S. 23023 5 сторінок. Control box for boat or car fire system actuator usually fixed on the boat dash board

Друкувати сторінку

Technical Bulletin

23023

1370

Technical specification operating Control Box.

Use instruction.

Control Box consist of two units, a central unit CPU with LCD large backlit display

designed to be installed in engine compartments and remote unit to activate and

control the system from the dash board.

The central unit receives activation signal from the remote unit pushing

down simultaneously both buttons for 3 sec (pict. 1).

The central red LED flashes, until the system operated after it stop to flash.

During the discharge, the pressure switch connected to the system will change its condition (it close the contact) and turn on

the red led "EMPTY" permanently, until the system will be reset.

The red led "EMPTY" is switched on even if there are leaks from the cylinder. In this case, call an authorised service

company of ABS.

The yellow led "FAULT" shows an anomaly from the IN1 - IN2 - IN3 - IN4 - IN5, and according to the set delays on the

outputs, it will generate the activation of the OUTPUT OUT1 - OUT2 - OUT3 - OUT4 - OUT5. After activation of the outputs,

the yellow led "FAULT" will switch off, and the red led "EMPTY", will be switched on.

The green led " POWER" indicates that the system is correctly operating

and it will be switched off in case of malfunction or discharge.

- Signal input:

IN1

Pressure switch ( N.C.)

IN2

Temperature detector

IN3

Thermosensittive cable

Remote activation (Button underglass)

IN4

IN5

Further alarm remote available

- Output control relay:

OUT1 Electric actuator

OUT2 Solenoid fuel electro valve solenoid fuel tank

OUT3 Closed shutters ventilation of the engine compartment

OUT4 Solenoid gas kitchen system (N.O.)

OUT5 Acoustic indicator

Program CPU

Decreases

Increases

Send Change screen

Program level 1

Push the button SEND (pict. 2) for 10 sec. until entry in the function level 1.

Select the language with button RX or LX (pict. 3).

Push "SEND" to change the screen.

Push the button RX or LX to enable or disable the system.

Program level 2

At the finish of the program level 1 "end input" push the button RX and LX together

(pict. 3) for 10 sec. until entry in the function level 2.

With button RX or LX can enable or disable the function of level 2.

a.b.s.

code

Lombardia street 310, 20861 Brugherio

Tel. +39 039 839631 - Fax. +39 039 8396349

e-mail:[email protected] - www.absfire.it - Capital 2.000.000

Technical data are subject to modification

for improvements without prior notice

S.r.l. (Milan) Italy

SEND

(pict. 2)

Data Sheet

Marine Con.Box

(pict. 1)

(pict. 3)

Code

Date

Check

Rev

Pag.

23023

25/05/15

3/5

benz

3/benz