Aqua Control AQUATIC 1HP FUSION Series Посібник користувача - Сторінка 3
Переглянути онлайн або завантажити pdf Посібник користувача для Відкритий фонтан Aqua Control AQUATIC 1HP FUSION Series. Aqua Control AQUATIC 1HP FUSION Series 14 сторінок.
Друкувати сторінку
• All nozzle builds are in Appendix A
• When building the Nozzle, it is best to work from inside out to provide room to work.
• Center Nozzle will always be installed last.
Im portant N otice on the FU SIO N Series M ulti-N ozzle
Com ponents Carry No W arranty W hen Assem bled Im properly
This Innovative Multi-Nozzle Casting was designed to offer you the flexibility to switch spray
patterns as desired. The screws provided can be inserted multiple times in various locations without
damaging the holes. Extra parts have been included as spares in the event they are needed.
Nozzles should be assembled using even and gradual tightening. The screws should be tightened
snuggly using hand tools only and opposing sides should be tightened evenly. Over-torquing the
screws may result in damages not covered under the manufacturer's warranty. Power tools are
not allowed.
The assembled nozzle should be handled by the base. Transporting the assembly using the
individual tube assemblies or components may result in damages not covered under warranty.
Nozzle components are warranted for 30 days and solely replaced due to manufacturing defects.
All other damages caused by improper handling and/or assembly will require replacement parts
purchased through your distributor.
There is a separate instruction sheet to use when installing the Optional Twister Module. If you
experience difficulty implementing the build for your preferred spray pattern based upon the
instructions provided, please contact Aquatic Technologies for assistance.
Unlike the pump itself, the Twister Module carries a one (1) year manufacturer's
warrantyagainst defects.
NOZZLE BUILD TIPS AND W ARNINGS
1HP & 2HP Fusion Series Owner's Manual
Page 3