AVLink HRM-2514 Посібник користувача - Сторінка 2

Переглянути онлайн або завантажити pdf Посібник користувача для Перемикач AVLink HRM-2514. AVLink HRM-2514 2 сторінки. Hdmi selector

Друкувати сторінку
Installation
Before the installation, making sure the selector and
monitor (projector) are turning off.
1. Making sure all equipments are turned off.
2. Plug the monitor cable into the HDMI OUT port
connector.
3. Plug the extension cables from HDMI port of DVD
player/TV receiver into the HDMI IN port connectors.
4. Plug the power adapter into the wall socket.
5. Connect the power adapter with the HDMI selector.
6. Turn on the monitor first.
7. All red LEDs will flash back and forth, otherwise, go
back to check the step 4 and 5.
8. Turn on the DVD player/TV receiver.
9. The LEDs green light turn on while the DVD player/TV
receiver have well been connected and maintaining
the activation.
Operation
1. Port selection
Press the button of "port selection switch" for
accessing the wanted DVD player/TV receiver.
The selected corresponding port will light on for the
red LEDs which indicating the port is actived.
2. IR remote control
Use "1", "2" key to select DVD player/TV receiver
that wanted DVD player/TV receiver.
Use "
", "
" key to select another DVD
player/TV receiver.
3. RS-232 control
You can operate and configure the Switcher via a remote
terminal session using RS-232. Follow the steps as
below to log into the Switcher by means of a RS-232
session (the example as below is for Hyper Terminal):
1. Connect the Switcher to your control PC with RS-232
cable.
2. Power on both Switcher and control PC.
3. Open the Hyper Terminal by clicking
Start│Programs│Accessories
Communications│Hyper Terminal on your control PC.
4. The New Connection – Hyper Terminal screen will
appear. Input the connection name and select a
representative icon. Then click OK.
5. Select the connecting port that you want to use, click
OK. Default port is COM1.
-4-
6. Set the Bits per second to 9600, Data Bits to 8
(Default), Parity to None (Default), Stop bits to 1
(Default) and flow control to None from the drop-down
list, click OK.

Technical Specifications

HDMI Input/Output Signal
Pin #
Signal
Pin #
1
TMDS Data 2+
11
2
TMDS Data 2 Shield
12
3
13
TMDS Data 2-
4
TMDS Data 1+
14
5
TMDS Data 1 Shield
15
6
16
TMDS Data 1-
7
17
TMDS Data 0+
8
18
TMDS Data 0 Shield
9
19
TMDS Data 0-
10
TMDS Clock+
Supported RS232 DCE Signal
Pin #
Signal
Pin #
1
N/A
6
2
Transmit Data
7
3
Received Data
8
4
N/A
9
5
Signal Ground
-5-
Signal
TMDS Clock Shield
TMDS Clock -
CEC
Reserved
(N.C. on device)
SCL
SDA
DDC/CEC Ground
+5 Power
Hot Plug Detect
© C&C TECHNIC TAIWAN CO., LTD. All rights reserved.
Trademarks:
Signal
All the companies, brand names, and product names
N/A
referred to this manual are the trademarks or registered
N/A
trademarks belonging to their respective companies.
N/A
N/A
-6-