Aqua Creek PORTABLE PRO POOL-AT LIFT Посібник з монтажу та експлуатації - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник з монтажу та експлуатації для Підйомні системи Aqua Creek PORTABLE PRO POOL-AT LIFT. Aqua Creek PORTABLE PRO POOL-AT LIFT 20 сторінок.

Друкувати сторінку

SAFETY & MAINTENANCE INSTRUCTIONS

Do not play on or around this lift

1. Check the PRO POOL LIFT

and that all hardware is properly tightened. If there are any worn parts, replace

them BEFORE using the Pro Pool Lift

888-687-3552 to order any parts.

2. Aqua Creek Products, LLC lifts shall be grounded per local codes.

3. At least ONCE A WEEK, the Pro Pool Lift

Do not spray the Pro Pool Lift

Wipe all surfaces clean with a damp, non-abrasive cloth. When cleaning the Pro

Pool Lift

, use non-abrasive soap and water. Avoid harsh chemicals and

disinfectants.

4. Always read the label instructions on any cleaner carefully before applying it to a

surface.

5. The WARNING & INTENDED USE labels on the Pro Pool Lift

maintained in readable fashion. If they become un readable or faded, please

replace the label immediately. Replacement labels are available from AQUA

CREEK PRODUCTS LLC. 1-888-687-3552.

CARE OF YOUR LIFT

Routine cleaning is an absolute necessity to ensure the integrity of the lift. Note that the

Aqua Creek Pool Lift should not be stored in a pump room or in a storage room where

pool chemicals are kept. Storing the lift near pool chemicals may cause rusting and other

damage to occur. Your Aqua Creek stainless steel lift is powder coated to protect the

stainless steel from rusting. Most rusting will occur at weld points, crevices, under

gaskets, rivets or bolt heads.

The choice of a proper cleaning product is up to the consumer and there are many to

choose from. Depending on the type of cleaning and the degree of contamination

(rusting), some products are better than others. For routine cleaning the products most

recommended are gentle soaps or detergents or dilute mixtures of ammonia. For

stubborn spots and stains try using soft scrub with some brisk rubbing.

DO NOT USE POOL WATER TO CLEAN USE ONLY FRESH

WATER

If the lift is used DAILY make sure to wash the lift at the end of the day. Wash the lift

off using a mild soap and a soft cloth. Make sure to pay special attention to weld points

and crevices. Do not use a bristled brush or steel wool to clean the lift. Check that the

lift is working properly and then place the battery on the charger. It is recommended that

the battery be charged after every day of use.

If the lift is used WEEKLY follow the same steps as above. Also be sure to check all of

the contact points (terminals) for damage or corrosion. If you notice corrosion gently

clean the terminals. To clean corrosion from the terminals use a q-tip and some rubbing

alcohol. If the corrosion is particularly stubborn try using a 3M scotch brite pad, but be

careful not to damage the terminals. Apply dielectric grease to the terminals after

cleaning them. This will help to prevent further corrosion. Do not leave the battery on the

lift. Always store the battery on the charger whenever the lift is not being used.

before each use to assure there are no worn parts

. You can call our customer service at 1-

must be cleaned with fresh water.

24v battery unit directly with any pressure.

need to be