Aqua Creek Products Mighty Voyager Інструкція з експлуатації - Сторінка 6
Переглянути онлайн або завантажити pdf Інструкція з експлуатації для Підйомні системи Aqua Creek Products Mighty Voyager. Aqua Creek Products Mighty Voyager 14 сторінок. Portable lift
Друкувати сторінкуMighty Voyager Assembly Instructions
3. Attach the seat belt through the loops in the seat base and
pinch the hook & loop material together. See diagram to
right.
4. Place the battery on the charger and bring to a full charge.
5. Remove the fully charged battery from the charger and
install it on top of the control box. The battery will line up
with the control box, and will 'click' when it properly locks
in place. Apply dielectric grease to the plug terminals,
including the o-ring seal, and then connect the battery
cable to the control box cable. NOTE: To extend battery life,
always store battery on the charger when the lift is not in
service.
6. Roll the lift to the area near the pool where it is to be used and then lock the rear casters.
7. Deploy both outriggers and twist the pressure foot on either side until they come into
contact with the ground. DO NOT OPERATE LIFT UNLESS OUTRIGGERS ARE DEPLOYED!
See FIGURE 3 below.
8. Operate the lift without a load to verify that the lift will operate properly in the selected
location. Check that there is enough clearance between the lift seat and the pool wall as
the chair extends into the water.
9. When lift is
confi rmed to be in
a proper location, a
facility may choose
to install a fi xing kit.
A fi xing kit will affi x
the lift to the deck
and is required for
most commercial
applications to be
ADA compliant. See
following page for
detailed instructions.
6
Copyright © 2020 Aqua Creek Products All Rights Reserved
LOOP ON TOP
FOR EASY ACCESS
THREAD THROUGH
SLOTS AND PINCH
TOGETHER TO HOLD
LOCK BRAKE
(BOTH SIDES)
ADA ANCHOR
IF REQUIRED
PRESSURE FOOT
OUTRIGGER DEPLOYED
(BOTH SIDES)
FIGURE 3
Revised 10/21/20