Aqua Creek Products REVOLUTION LIFT SD SLING F-706RLSS Посібник - Сторінка 18
Переглянути онлайн або завантажити pdf Посібник для Підйомні системи Aqua Creek Products REVOLUTION LIFT SD SLING F-706RLSS. Aqua Creek Products REVOLUTION LIFT SD SLING F-706RLSS 20 сторінок.
Друкувати сторінкуIf the battery is fully charged and the lift is not moving then:
2.
Check all cords:
Check that the cords are properly plugged in. Start by unplugging the remote and the actuator
cord from the control box. Once these cords are removed check the ends for corrosion or
damage. Plug the remote cord back in by lining up the raised tab on the plug to the grooved line
on the control box outlet. Note that these cords require some force to plug them in fully. You
will know they a c o r r e c t l y i n s e r t e d w h e n y o u h e r e a " p o p p i n g s o u n d " . T h e c o r d s w i l l b e
recessed into the outlet. If they are flush with the outside of the outlet they are not plugged in
fully and the lift will not function. Make sure you do this for both cords.
NOT inserted fully.
If you have checked all t h e c o r d s a n d t h e l i f t s t i l l d o e s n ' t mo v e :
3.
Check the contact points:
After you have fully charged the battery and checked the cords to make sure they are properly
plugged in, check to make sure the contact points are not corroded or bent. If the contact points
are corroded take some rubbing alcohol and a q-tip and clean off the points. After cleaning the
contact points it is recommended to put some dielectric grease on the contact points (terminals)
to help ensure good electrical contact and prevent corrosion. Then reinstall the battery on top of
t h e c o n t r o l b o x . Ma k e s u r e y o u h e a r a " c l i c k " , w h i c h i n d i c a t e s t h a t t h e b a t t e r y i s c o r r e c t l y
seated. The lift will not work if the battery is not seated correctly.
If the lift stops moving over the water and is stuck:
4.
Push the emergency button:
If the lift gets stuck out over the water use a pen or pencil tip and stick it into the emergency
button on the front of the control box to retract the lift. Note the lift will not retract if the battery
is not fully charged or if the control box is not working. The emergency button only overrides
the remote in case it has gone bad. If this does not retract the lift then chances are the remote is
fine and you either have a problem with the battery, the control box, or the cords are damaged or
not plugged in properly.
Use a pen or pencil tip to
push in the small black circle
located next to the word
emergency, on the front of
the control box.
Silver tabs are the contact
(terminal) points.
Fully inserted.
18