Aqua Creek Products Titan F-600TLNA-02 Посібник - Сторінка 7
Переглянути онлайн або завантажити pdf Посібник для Підйомні системи Aqua Creek Products Titan F-600TLNA-02. Aqua Creek Products Titan F-600TLNA-02 13 сторінок.
Друкувати сторінку
CONTROL ARM
LIFTING ARM
STEP 5: ADJUST THE SEAT POSITION
The SEAT ASSEMBLY will arrive attached to the SEAT ARM
adjusted to its highest position. To adjust the SEAT ASSEMBLY
to a lower position remove the hardware as shown below.
Slide the SEAT ASSEMBLY to its desired position (in 4 inch
increments) and reinstall the hardware. The maximum
adjustment is 16 inch (down).
DO NOT ATTACH THE SEAT ASSEMBLY ANY LOWER THAN THIS
– ALWAYS USE THE TWO (2) SUPPLIED BOLTS TO ATTACH THE
SEAT ASSEMBLY TO THE CHAIR ARM!
NOTE: For most applications, such as pools with a fl at deck,
the seat will be installed in its lowest position. For applications
where a wall or curb must be cleared the seat should be
installed in a higher position. In its highest position the seat
will clear a 26 inch [660mm] high wall (with the pull-out
legrest).
3/8" X 2"
SHOULDER BOLT
5/16" X 4 1/2"
HEX BOLT
Copyright © 2020 Aqua Creek Products All Rights Reserved
Titan Assembly Instructions
STEP 4
1/2" X 3"
SHOULDER
BOLT (2)
SEAT ARM
3/8" FLAT WASHER (2)
3/8" NYLOCK NUT (2)
STEP 4: INSTALL SEAT ARM
Locate the SEAT ARM and the following hardware:
•
(2) 1/2" x 3" SHOULDER BOLT
•
(2) 3/8" FLAT WASHER
•
(2) 3/8" NYLOCK NUT
Install the SEAT ARM at the ends of the CONTROL
ARM and LIFTING ARM as shown in the fi gure to the
left. Tighten the NYLOCK NUTS until snug as shown in
PHOTO 4. DO NOT OVERTIGHTEN!
(NOTE: MAKE SURE THE SEAT IS FACING AWAY FROM
THE MAIN ASSEMBLY)
SEAT-ARM
HOLES AT 4"
INTERVALS
ALLOW FOR
ADJUSTMENT
OVER 16"
RANGE
SEAT ASSEMBLY
ADJUSTED TO
LOWEST POSITION
(SEAT WILL ARRIVE
AT HIGHEST
POSITION)
STEP 5
STEP 5
STEP 5
STEP 5
5/16" FLAT
WASHER (3)
5/16" NYLOCK
NUT (2)
MAIN
ASSEMBLY
7
Revised 1/2/20