Dexter Power NC850RS Посібник користувача - Сторінка 17

Переглянути онлайн або завантажити pdf Посібник користувача для Пила. Dexter Power NC850RS. Dexter Power NC850RS 20 сторінок.

Original Instructions

Flush cutting

With the use of flexible bimetal saw blades, projecting items (i.e. water pipes, etc.) can be sawed off flush to the wall. Pay attention

that the saw blade always extends beyond the diameter of the pipe being sawed. Danger of kickback.

Position the saw blade side wards against the wall and apply some lateral pressure via the tool so that the edge of the pivoting

footplate 2 faces against the wall. Switch the tool on and make the cut, applying constant lateral pressure.

SERVICE & MAINTENANCE

Always disconnect the device before performing any adjustment or maintenance operation. If the supply cord is damaged,

it must be replaced by the manufacturer or its service agent in order to avoid a hazard.

Disconnect from the power supply immediately if the supply cord is damaged. Take care not to expose this tool to the rain.

If the carbon brushes need to be replaced, have this done by a qualified repair person (always replace the two brushes at the

same time.

Cleaning

Avoid using solvents when cleaning plastic parts. Most plastic parts are susceptible to damage from various types of commercial

solvents and may be damaged by their use. Use clean cloths to remove dirt, carbon dust, etc.

Lubrication

All the bearings in this tool are lubricated with a sufficient amount of high grade lubricant for the life of the unit under normal

operating conditions, therefore no further lubrication is required.

Dexter Power