Dexter Power NC500JS Посібник користувача - Сторінка 14

Переглянути онлайн або завантажити pdf Посібник користувача для Акумуляторна пила Dexter Power NC500JS. Dexter Power NC500JS 20 сторінок.

Original Instructions

3. Speed controller

4. Dust extraction tube

5. Tool-less blade clamp

6. Blade guide

7. Shoe plate

8. Hex key

SAFETY INSTRUCTIONS

Explanation of symbols

In this manual and/or on the machine the following symbols are may used:

WARNING-To reduce the risk of injure,user must read instruction manual.

Class II machine – Double insulation – You don't need any earthed plug

Denotes risk of personal injury, loss of life or damage to the tool in case of non-

observance of the instructions in this manual

Indicates electrical shock hazard.

Immediately unplug the plug from the mains electricity in the case that the cord gets damaged and during

maintenance.

Wear eye protection

Wear dust mask

ASSEMBLY

To install the blade

Fig.2

WARNING: Always ensure that the jig saw is switched off and plug is removed from the power point before making any

adjustment.

It is recommended to wear protective gloves when inserting or replacing blade.

1. Pull the tool-less blade clamp backwards and hold it.

2. Place the saw blade as far as it will go, ensuring that the blade rear edge is located and supported by the blade roller guide.

3. Release the tool-less blade clamp.

4. Run the jig saw under no load to check that it runs smoothly and the blade is secure before using it to cut any materials

CAUTION: The blade roller guide supports the blade when cutting and must at all times rest against the back edge of the blade.

It should rotate freely.

To remove the blade

Pull the tool-less blade clamp backwards and remove the blade.

Dexter Power