A.J.Antunes 9210825 Посібник - Сторінка 12

Переглянути онлайн або завантажити pdf Посібник для Тостер A.J.Antunes 9210825. A.J.Antunes 9210825 20 сторінок. Club toaster

CLUB TOASTER CTX-200L

Replacing Belt Wraps

Over time, the Belt Wraps will begin to show signs of

wear. This wear appears in the form of tears or discol-

oration of the belt. The Belt Wraps should be replaced

at least once a year.

NOTE: Belt Wraps should be removed ONLY during

Belt Wrap replacement or when required in a

service situation.

REMOVING BELT WRAPS

1. Turn the power off.

2. The toaster enters a cool down mode and dis-

plays OK to Clean. The fans continue to run.

This cool down period continues for 45 minutes

and shuts the unit down automatically when com-

plete.

NOTE: You do NOT need to wait for the count down

to complete. Continue with the steps as soon as

you see OK to Clean.

emove the Bun Feeder and Bun Buffer from the

toaster (refer to Figure 1):

4. Press

to stop the Belt Wraps from rotating.

5. Open the Front Cover and Top Cover (Figure 8).

6. Refer to Figure 10. Push up and then drop down

both of the Front and Rear Bottom Rollers until

they lock into place. This will remove the tension

on both Belt Wraps.

7. Locate the Connecting Pin on both Belt Wraps

(rotate belts by hand if necessary). Disconnect the

ends of the Belt Wraps by sliding one end of the

Belt off the pin (Figure 11).

8. Remove both Belt Wraps and discard.

MAINTENANCE (continued)

Push both Bottom Rollers up

and down to lock into place.

This loosens Belt Wraps.

Figure 10. Loosening Belt Wraps

Figure 11. Disconnecting Belt Wraps

P/N 1010993 Rev. H 03/15

Unhook end of

Belt Wrap from

Pins

McDonald's