A.J.Antunes 9100480 Посібник користувача - Сторінка 14
Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка A.J.Antunes 9100480. A.J.Antunes 9100480 20 сторінок. Miracle steamer
Друкувати сторінку
MIRACLE STEAMER
Problem
Unit heats but there
is little or no steam
produced
and/or
The product requires
more steaming than
usual.
Excessive con-
densation in Food
Compartment.
Steam coming out
around top covers or
sides.
A.J. Antunes & Co.
TROUBLESHOOTING (continued)
Possible Cause
Filter Strainer is restricted.
Unit is not being cleaned properly
(daily/monthly).
Programming and/or SHO, H2O
values were adjusted/changed
improperly.
Insufficient or excessive calcium/
mineral deposits on the Generator
surface.
Generator surface is bare.
Generator Steam Ports are
restricted.
Generator Cover is warped or loose.
Generator Diffuser is missing.
Generator surface temperature is too
low.
Programming and/or SHO and H2O
values were adjusted improperly.
Generator Cover's Wing Nut is
loose.
Generator Cover is warped.
Corrective Action
Check and clean the Filter Strainer as described in
the Maintenance section of this manual.
Clean unit daily and monthly as described in the
Maintenance section of this manual.
Reprogram the SHO and H2O values as described
in the Programming section of this manual.
Verify a thin layer of calcium/mineral deposits is
present on the Generator surface. Refer to the
Maintenance section of this manual.
Generator surface must have a thin calcium/min-
eral coating for proper steaming. Refer to the
Maintenance section of this manual.
Clean the Steam Ports as described in the
Maintenance section of this manual.
Verify that the Generator Cover's Wing Nut is tight.
If noticeable steam escapes around the Generator
Cover, replace the cover.
Install Generator Diffuser or replace if missing.
Verify Generator surface temperature to be 380–
420°F (193–215°C).
Reprogram the SHO and H2O values as described
in the Programming section of this manual.
Tighten Wing Nut.
Replace Generator Cover.
14
P/N 1010456 Rev. C 08/12