A.J.Antunes roundup MS-150 Посібник користувача - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник користувача для Кухонна техніка A.J.Antunes roundup MS-150. A.J.Antunes roundup MS-150 16 сторінок. Miracle steamer

Друкувати сторінку

TroubleShooTinG (continued)

problem

Unit heats but there is little or no

steam produced

and/or

The product requires more steaming

than usual.

Excessive condensation in Food

Compartment.

Steam coming out around top covers

or sides.

possible Cause

Filter Strainer is restricted.

Unit is not being cleaned properly (daily/monthly).

Programming and/or SHO, H2O values were adjusted/

changed improperly.

Insufficient or excessive calcium/mineral deposits on

the Generator surface.

Generator surface is bare.

Generator Steam Ports are

restricted.

Generator Cover is warped or loose.

Generator Diffuser is missing.

Generator surface temperature is too low.

Programming and or SHO and H2O values were

adjusted improperly.

Generator Cover's Wing Nut is loose.

Generator Cover is warped.

Corrective action

Check and clean the Filter Strainer as described in

the Maintenance section of this manual.

Clean unit daily and monthly as described in the

Maintenance section of this manual.

Reprogram the SHO and H2O values as described in

the Programming section of this manual.

Verify that thin layer of calcium/mineral deposits

is present on the Generator surface. Refer to the

Maintenance section of this manual.

Generator surface must have a thin calcium/

mineral coating for proper steaming. Refer to the

Maintenance section of this manual.

Clean the Steam Ports as described in the

Maintenance section of this manual.

Verify that the Generator Cover Wing Nut is tight.

If noticeable steam escapes around the Generator

Cover, replace the cover.

Install Generator Diffuser or replace if missing.

Verify Generator surface temperature to be 380–

420°F (193-–215°C).

Reprogram the SHO and H2O values as described in

the Programming section of this manual.

Tighten Wing Nut.

Replace Generator Cover.

P/N 1010881 Rev. F 03/12