DeZurik G6-C4 Посібник - Сторінка 13

Переглянути онлайн або завантажити pdf Посібник для Контролер DeZurik G6-C4. DeZurik G6-C4 16 сторінок. Cylinder operated actuator

Reassembling Actuator

7. Place a new gasket (B26) on the cylinder head.

8. Install the cylinder/rack rod assembly by sliding the rack rod through the rack (B4) and fasten

the cylinder to the housing (B1) with screws (B27).

NOTE: If the rack rod is not attached to the cylinder assembly, clean the threads of both the rack rod and

the cylinder shaft, then apply Loctite to the cylinder shaft threads and screw the rack rod onto the cylinder

shaft.

9. Slide the spring washers (B21) and screw the jam nut (B22) onto the rack rod (B6) until the

spring washers are completely compressed, then loosen the jam nut just until the spring

washers return to normal shape. See Table C for spring washer arrangement.

August 2012

(Continued)

Figure 8 – Gear and Rack Alignment

Page 13

Cylinder Operated G-Series Actuator

DeZURIK

D10455