DeZurik P41D Інструкція - Сторінка 7

Переглянути онлайн або завантажити pdf Інструкція для Позиціонери клапанів DeZurik P41D. DeZurik P41D 11 сторінок. Pmv positioners

Adjustments

(continued)

3. Adjust the length of the rod until the valve is in the position corresponding to the minimum input

signal.

Zero Adjustment

1. Set the positioner input signal at the minimum value of its range, for example, 4mA for a 4-

20mA range.

2. Turn the zero adjust screw clockwise until the valve closes. (See Figure 1 for location of

adjusting screws.)

3. Increase the instrument signal slightly above the minimum range value.

Note: If the valve does not begin to open, turn the zero adjust screw counterclockwise until the valve

just starts to move.

4. Since the zero and range adjustments are interrelated, check the range setting and readjust it, if

necessary.

1. Set the positioner input signal at 20mA.

2. Turn the range adjust screw until the valve is in the OPEN position.

3. Decrease the input signal slightly.

4. If the valve does not begin to close, turn the range adjust screw until the valve just starts to

move.

5. Since the zero and range adjustments are interrelated, check the zero setting and readjust it, if

necessary.

August 2012

Page 7

DeZURIK

D10112