Avocent Cyclades PM10i-32A Посібник зі швидкого встановлення

Переглянути онлайн або завантажити pdf Посібник зі швидкого встановлення для Блок розподілу електроенергії Avocent Cyclades PM10i-32A. Avocent Cyclades PM10i-32A 2 сторінки. Cyclades pm series power distribution unit
Також для Avocent Cyclades PM10i-32A: Технічна специфікація (2 сторінок), Технічна специфікація (2 сторінок), Брошура (6 сторінок)

Avocent Cyclades PM10i-32A Посібник зі швидкого встановлення
The following instructions will help you
connect your Cyclades PM IPDU.
Should you require further assistance, consult
your installer/administrator/user guide.
1
Mounting the PM IPDU (PM8i, PM10 or
PM10i models)
To rack mount or wall mount the PM IPDU,
locate the appropriate sets of holes on the unit.
To rack mount a unit, connect one bracket to
each side of the box using the supplied Phillips
head screws.
Use the mounting hardware recommended for
your rack to mount the PM IPDU. The RJ-45
cable included in the PM IPDU package is
minimum flame rated VW-1 or FT-1 and has a
maximum length of 10 feet (3 meters).
NOTE: To wall mount a PM IPDU (zero U
model), securely mount it by using a #10 (4.8
mm or 0.19 in or 3/16 in) or larger screw, or use
a drywall fastener rated min. 25 lb (11.34 kg).
2
Daisy-chaining PM IPDUs
You can manage a maximum of 128 outlets from
a single workstation by connecting slave PM
IPDUs to the master PM IPDU. Connect one
end of an RJ-45 cable to the Out port of the
main Cyclades PM IPDU, which is connected
to a workstation, a Cyclades console port or
KVM switch AUX port (master). Connect the
other end of the RJ-45 cable to the In port of the
secondary PM IPDU (slave). To attach another
To Contact Avocent Technical Support
Avocent, the Avocent logo, The Power of Being There and Cyclades are registered trademarks of Avocent Corporation or its affiliates. All other marks are the property of their respective owners. ©2006 Avocent Corporation. All rights reserved.
Quick Installation Guide
Cyclades
Intelligent Power Distribution Unit
To connect the PM IPDU
A1
A1
A1
A1
PM IPDU to the chain, connect its In port to the last
Out port in the chain. Repeat these steps until you
have connected the desired number of PM IPDUs.
NOTE: Power the PM IPDU in order to begin
managing power of its connected devices. The
PM IPDU must be powered by a receptacle with
adequate circuit protection.
CALL (888) 793-8763
The Power of Being There
PM
®
PM IPDU
PM IPDU
PM IPDU
PM IPDU
Switch
Server
3
Accessing the console
Connect an RJ-45 cable to the console port on
the PM IPDU. Connect the other end of the RJ-45
cable to an RJ-45 to DB-9F adaptor shipped with
the PM IPDU.
Connect the adaptor to a DB-9 serial port on a
workstation. You may need a USB serial adaptor
in order to connect to the server.
VISIT www.avocent.com/support
®
Power Source
DOWNLOAD www.avocent.com
590-680-501A