BIL Skoots SK5000 Посібник оператора Оригінальні інструкції - Сторінка 10

Переглянути онлайн або завантажити pdf Посібник оператора Оригінальні інструкції для Підйомні системи BIL Skoots SK5000. BIL Skoots SK5000 12 сторінок. Moving system
Також для BIL Skoots SK5000: Посібник (9 сторінок), Інструкція з експлуатації та технічного обслуговування (2 сторінок)

Care and maintenance

Before each use,

visually check for

wear and defects

such as...

Six monthly –

oil level in hydraulic

jacks...

(unless leakage of fluid

is noticed during pre-

use check whereby oil

level should be assessed

before use or otherwise

remove from service)

In case of difficulty contact...

BIL Materials Handling, Porte Marsh Road, Calne, Wiltshire SN11 9BW, UK

Tel: +44(0)1249 822222 Fax: +44(0)1249 822300

email: [email protected] web: www.bilhandling.co.uk

Telephone +44(0)1249 822 222 www.bilhandling.co.uk

– Ensure that a pair of straps with intact webbing, buckles/ratchets and

hooks are available.

– Cut, chunked or damaged wheels on main frames or outriggers.

– Missing mats.

– Leaking rams.

– Toe-plate not at 90 degrees.

– Damaged directional locking mechanisms on main body castors.

– Check the state of markings and that the markings remain as the original one.

– With jacks standing vertically and fully retracted i.e. unraised, unscrew the

top filler bolt using an 8mm allen key. Carefully remove the top filler bolt/

dipstick. Wipe clean the surface of the dipstick and insert carefully back

into the oil before removing once more to check the level of fluid. Add

hydraulic oil grade Varpress 68 so fluid level is between the notched

markers on the dipstick plug. Tighten the filler bolt using the allen key.

If a top-up of hydraulic oil is required use only Varpress 68VG.

NEVER USE ENGINE OIL OR BRAKE FLUID.

– Store Skoots upright at all times.

– Jacks should be maintained and repaired in accordance with the manufacturer's

instructions. Such work should be carried out by qualified persons.

– No modifications shall be carried out which adversely affect the compliance

of the jack with this standard.