ALLIED MEDICAL Ki Mobility Catalyst 5 Посібник з налаштування - Сторінка 6
Переглянути онлайн або завантажити pdf Посібник з налаштування для Інвалідний візок ALLIED MEDICAL Ki Mobility Catalyst 5. ALLIED MEDICAL Ki Mobility Catalyst 5 11 сторінок.
Друкувати сторінку
Adjusting Rear Seat Height with Universal Axle Plate
1. Remove rear wheels from quick release axle
2. Use a 10mm spanner to remove the nuts holding the axle in place (the recessed edge on the
axle plate holds the bolt head, so only one spanner is required
3. Reset to desired height on frame. Tip: lower and higher heights can be achieved by turning
the axle plate up or down as shown in the diagram below.
4. Re-install the bolts into the holes that achieve the desired height, tighten the nut using a
10mm spanner
Note: with this axle plate, camber is achieved with the lowest located washers that are between
the axle plate and the frame. See diagram below for different camber angles that can be
achieved.
Adjusting Centre of Gravity
1. Remove rear wheels from quick release axle.
2. Loosen nut on outside of axle using a 24mm spanner until you are able to move the axle
receiver forward or back along to the next groove (on the inside of the axle plate). Move
forward for active centre of gravity or rearward for more stable.
3. Be careful to align the nut in the selected groove the correct way up so that it will hold in
place when tightened.
4. Re-tighten outside nut with 24mm spanner.
5. Repeat steps on opposite side taking care to ensure the same COG position is selected on
both sides.