Avonic CM-CON100 Посібник користувача - Сторінка 11

Переглянути онлайн або завантажити pdf Посібник користувача для Камера спостереження Avonic CM-CON100. Avonic CM-CON100 16 сторінок. Ptz camera controller
Також для Avonic CM-CON100: Посібник користувача (12 сторінок), Посібник користувача (10 сторінок), Посібник користувача (13 сторінок), Посібник користувача (11 сторінок)

Друкувати сторінку
Avonic CM-CON100 Посібник користувача

NON-Setup Menu

PTZ controls
Move the Joystick up, down, left and right (1) to control the camera. Turn the joystick clockwise to zoom
in (2) and anti-clockwise to zoom out (3). The button on the joystick is for switching between zoom and
focus (3). See pictures below:
1
Zoom and Focus
It is possible to switch to Focus mode in two different ways: Using the Joystick button (see picture 3
above), or using the F2 button. Press F2 to switch to Focus mode and twist the joystick left and right to
focus. Press F1 to switch back to Zoom mode. Note that you need to twist the joystick again to autofocus
the camera and zoom out.
SET/ CALL Preset Position
With the CON100 it is possible to set the camera in a desired position as a preset. You can call that preset
when you need it.
Set preset*
1.
Move the joystick to set the camera in the desired position.
2.
Press short number 1 button (or another number button between 0 - 255).
3.
Press short the
CALL preset*
1.
Press number 1 button (or another number button between 0 - 255).
2.
Press the
* Note also that it is possible to easily confuse the Preset/ CALL functionality with setting up camera
(protocol) Address and ID number! (see page 12) Keep in mind in which feature and menu you are.
Delete Preset Position
To delete a preset do the following:
1.
Press the number button of the preset you want to delete.
2.
Wait untill the camera moves to the position of that preset number.
3.
Press again the number button of the preset you want to delete.
4.
Press long the SET number button.
5.
[CLR PRESET:] shows shortly on the screen of the controller.
6.
The Preset is now deleted and empty.
How to switch to another camera
See page 12 how to set an ID for your camera, if you have multiple camera's to control with the CON100.
1.
Press in the NON-Setup Menu camera number
2.
Press the camera button
www.avonic.com
2
to set the preset.
to call the preset. Camera moves automatically to the postion of that preset number.
3
Back to top
11